Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ironton 30091
Summary of Contents for Ironton 30091
- Page 1 ELECTRIC METAL CUTTING SHEAR OWNER’S MANUAL WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item# 30091...
-
Page 2: Intended Use
Thank you very much for choosing an Ironton product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. -
Page 3: Important Safety Considerations
IMPORTANT SAFETY CONSIDERATIONS Safety Warnings and Precautions WARNING: When using tool, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment. Read all instructions before using this tool! Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents. ... -
Page 4: Specific Safety Rules
Remove adjusting keys or wrenches before turning the power tool on. A wrench or a key that is left attached to a rotating part of the power tool may result in personal injury. Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the power tool in unexpected situations. -
Page 5: Tool Use And Care
contains at least the minimum wire size required. (See Figure A) If you are using an extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size. If you are using an extension cord outdoors, make sure it is marked with the suffix “W-A”(“W” in Canada) to indicate it is acceptable for outdoor use. -
Page 6: Operation
Maintain tools with care. Keep Cutting tools maintained and clean. Properly maintained tools are less likely to bind and are easier to control. Do not use a damaged tool. Tag damaged tools <<Do not use >> until repaired. Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may become hazardous when used on another tool. -
Page 7: Maintenance
Adjusting the cutting blades If the tool is operating properly, but is not cutting satisfactorily, you may have to adjust the blades. 1. Before attempting adjustment, turn off and unplug the tool. 2. Using a probe through the motor vents in the side of the cover (48), turn the fan until the cutting blades are open to the maximum amount. -
Page 8: Replacing Carbon Brushes
shear blade (12) but leave it just loose enough to slide. 5. The upper shear blade (12) has an adjusting screw (8) and screw (6) that are used to adjust the blade’s position. The screw (6) should be loosened with a wrench. Then the lock nut (7) should be loosened and held using a box-end wrench (not included) and the adjusting screw can be adjusted. - Page 9 they were removed. 4. To replace a carbon brush (42), insert it into the brush holder (41) carbon end first, with the spring end to the outside. Replace the brush cap (43) and tighten it by turning clock wise. NOTE: When replacing carbon brushes (42) do not replace only one brush. Always replace both carbon brushes at the same time.
-
Page 10: Diagram & Parts List
DIAGRAM & PARTS LIST Page of 12... - Page 11 For replacement parts and technical questions, please call 1-800-222-5381. Page of 12...
- Page 12 WARNING Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, •...
Need help?
Do you have a question about the 30091 and is the answer not in the manual?
Questions and answers