Advertisement
Quick Links
INTRODUCTION
This Voice Transmitter has been specifically designed for use in combination with the Voice Pager (receiver) model RP-800R, for
the following purposes :
-
as a transmitter for Voice Paging Systems in Tourists Guided Tours
-
as a transmitter for Voice Paging Systems in Conferences, Congresses, Meetings, Voice Interpretation, etc.
-
as a transmitter for Voice Paging Systems in stores, hotels, restaurants, resorts, factories, warehouses, offices, shops,
motorcycle driving schools, etc. and wherever a message or a voice communication from a main transmitter must be received
by either one or more groups of persons or by a single person.
The transmitter operates on the 860 MHz UHF FM band, which is usually free from interferences. Transmitter is fully programmable
by the system manager in the PROGRAM mode. Please read the following operating instructions before using the radio.
KEYS AND CONTROLS
1.
High efficency Antenna
2.
UP Key
3.
Hole for Necklace
4.
DOWN Key
5.
Window for Operator Card
6.
Desk Charger Contacts
7.
MO (MODE) Key
8.
EMG Key
9.
Power ON-OFF Key
10. TX Key
11. Belt Clip
12. Battery door
13. Backlighted LCD
14. Microphone Jack
RP-800T
860 MHz UHF FM VOICE TRANSMITTER
OPERATING MANUAL
LCD DISPLAY
A.
Transmitting Icon
B.
Channel Number
C.
Battery Level Indicator
D.
EMG Channel Icon
E.
VOX (Handsfree use) Icon
BATTERY INSTALLATION
1.
Remove the Belt Clip (11). To
remove the belt clip, pull the block
tab toward exterior and slide the
clip toward the up side of the unit.
2.
Slide down and remove the
battery door (12) by unlocking the
block tab.
3.
Install 3 x AA size batteries.
Please respect correct polarity.
4.
Re-install the battery door (12).
5.
Re-install the Belt Clip (11).
Advertisement
Related Manuals for Intek RP-800T
Summary of Contents for Intek RP-800T
- Page 1 RP-800T 860 MHz UHF FM VOICE TRANSMITTER OPERATING MANUAL INTRODUCTION This Voice Transmitter has been specifically designed for use in combination with the Voice Pager (receiver) model RP-800R, for the following purposes : as a transmitter for Voice Paging Systems in Tourists Guided Tours as a transmitter for Voice Paging Systems in Conferences, Congresses, Meetings, Voice Interpretation, etc.
- Page 2 BATTERY CHARGING / MULTIPLE DESK CHARGER (Mod. MDC-800) When the battery capacity is low, the Battery Level Indicator (C) shows one bar only. Recharge batteries at this time. Otherwise the transmitter will be automatically switched OFF after few minutes. When the battery capacity is low, switch OFF the transmitter and insert it in the Multiple Desk Charger.
- Page 3 Channels Table VOX Setting In the PROGRAM MODE press the MO Key (7) until the Channel Number (B) blinks. Press again the MO Key (7) until V Icon (E) appears and the VOX level blinks on the LCD Display (13). Press the UP (2) or DOWN (4) keys to select the desired VOX Level, from 1 (high sensitivity) to 3 (low sensitivity).
- Page 4 DECLARATION OF CONFORMITY Produced, imported and distributed by : INTEK S.R.L. Europe Head Office 16 via Guglielmo Marconi, 20090 Segrate, Italy Tel. +3902 2695 0451 - Fax. +3902 2695 2185 www.intek-radios.com e-mail : intek.com@intek-com.it...