Related Manuals for Dension Wi-Drive
Summary of Contents for Dension Wi-Drive
- Page 1 Dension Wi-Drive Dension Wi-Drive creates a WiFi hotspot using the internet connection of a 3G USB modem. Dension Wi-Drive User's Manual v1.0...
- Page 2 Once Wi-Drive is installed in your car, you can begin with setting up its internet connection settings and adjust WiFi parameters. You will need to be in the WiFi range of Wi-Drive and it needs to be powered on (the MOD light should flash slowly in green colour).
- Page 3 Enter the default administration password “admin” and click the Login button. You are now on the settings page of your Wi-Drive, where you can set up your internet connection and WiFi preferences. Please consult the description of each setting in the table below, and set them accordingly.
- Page 4 In the above cases, please contact your mobile network operator and ask for these settings (APN, username, password, DNS servers, gateway). Enable Check this box if you also want Wi-Drive to roaming connect to foreign networks. Beware of high data roaming costs. Enable on-...
-
Page 5: Leds And Buttons
Should you need to contact Technical Support, please include this information in your request. The page also informs you about your internet connection status. 2 LEDs and Buttons 2.1 LED flashes and their meaning Wi-Drive indicates its status via the dual-color LED with the label “MOD”. Green State Very slow Standby... -
Page 6: Operation
3 Operation If your Wi-Drive is installed and fully set up, it will power up when the ignition of the car is on. After powering up, it will connect to the internet and you can start using the WiFi hotspot. -
Page 7: Firmware Upgrade
5 Firmware Upgrade The operating system of Wi-Drive (firmware) can be upgraded via connecting a USB disk to one of the USB ports. For detailed instructions, consult the Release Notes that came with your firmware upgrade package. -
Page 8: Installation
8.2 Plug & Play For a plug and play connection follow these steps: 1. Connect the cigarette lighter cable to the power connector of Wi-Drive 2. Connect the USB 3G modem to the lower connector of the double USB port 3. - Page 9 8.3 Fixed installation If you want to have a fixed installation, with Wi-Drive possibly hidden, follow these steps: 1. Connect the wire power wire harness to the cars electrical system. The red wire needs to be connected to constant +12V with a supply of 1 Amps at least.
Need help?
Do you have a question about the Wi-Drive and is the answer not in the manual?
Questions and answers