jcb -BC26 Safety And Operating Manual Original Instructions page 20

Engine will not start.
Engine does not stop
when the On/Off
switch is off.
Engine starts but will
not accelerate.
Engine starts
will only run at high
speed and at half
choke.
SO53 3LE
Customer Helpline 0845 600 5526 Monday to Friday 09.00 to 17.00
www.JCBdiy.com
JCB-BC26_960443002-01_Manual_final.indd A20 JCB-BC26_960443002-01_Manual_final.indd A20
Engine is flooded.
Electrical connection is
loose/unplugged.
Not enough time given
for the engine to warm
up.
but Carburetor
adjustment.
 Remove spark plug, then turn
the unit so the spark plug hole is
aimed at the ground.
 Set the choke lever to "Run"
position and pull starter grip 10 to
15 times. This will clear excessive
fuel from the engine.
 Remove
product.
 Clean and reinstall the spark
plug.
 Clean up any spilled fuel and
move at least 9 m away before
restarting.
 Pull starter grip 3 times with the
choke lever at "Run" position.
 If the engine does not start, set
the choke lever to "Full" choke
position and repeat the normal
starting procedure.
 If the engine still fails to start,
repeat procedure with a new
spark plug.
 Set the choke lever to "Full" choke
position to stop the engine.
 Immediately
product.
 Check
connection at the bottom of the
trimmer is properly connected.
 Contact a service dealer if the
problem persists.
 Allow the engine to completely
warm up.
 If the engine does not accelerate
after 3 minutes, contact a service
dealer.
requires Contact a service dealer.
any fuel from the
stop using the
that the electrical
12/2/2010 5:38:02 PM 12/2/2010 5:38:02 PM