Summary of Contents for Venue Full Isolation D.I.
- Page 1 V E N U E F u l l I s o l a t i o n D . I . U S E R ’ S G U I D E w w w . l r b a g g s . c o m / v e n u e...
- Page 2 NOTE: The preamp cannot be phantom powered through the D.I. 2. Plug your guitar into the INPUT of the Venue D.I. (upper right hand side of the box) and a cable to either the 1/4” OUTPUT (upper left hand side) or the XLR output located on the back panel of the unit.
- Page 4 The treble control is a 12dB boost/cut centered at 10kHz. F. Notc h The Venue D.I. incorporates our proprietary Garrett Null anti-feedback notch filter. Sonically it is virtually invisible and it can be used to sweep the primary feedback range of an acoustic guitar (60Hz - 360Hz) to cut out a frequency that is causing feedback or ringing.
- Page 5 How to use the Notch Filter First plug your guitar into an amp or PA through the Venue D.I. and turn the volume up to the point where it begins to feed back or where a particular note rings out louder than the others.
- Page 6 NOTE: When using a DC Power Supply, the battery check circuit will show the level of the DC Power Supply. To check the battery level, first remove the DC Power Supply from the DC Input on the Venue D.I. K . Tu ne r A 1/4”...
- Page 7 L . Volume The master volume, located in the upper right of the control panel, will be used to set the level of the sound coming out of the 1/4” output ONLY. It will not effect the transformer coupled D.I. Output, which is pre-set at line level. This will allow you to adjust the level to your amplifier without changing the level to the PA system.
- Page 8 Plugging into the input will turn the system on, therefore unplugging will turn the system off. Before unplugging from the Venue D.I. be sure to mute the sound system or amplifier, or a loud pop will occur.
- Page 9 The voltage must be greater than 7.5VDC and less than 12VDC. However, you can use any amperage that is 100mA or greater. IMPORTANT: Polarity of power supply must match polarity marked on back of Venue: Tip (-), Ring (+).
- Page 10 S P E C I F I C A T I O N S 1/4” INPUT Input Impedance 10 megohms Preamp Gain -12dB to +26dB Input Level -25dBv to +1.8dBv (.053Vrms to 1.23Vrms) Notch -21dB, sweepable from 60Hz to 320Hz, 1/8 Octave Bass +/- 12dB @ 90Hz Lo Mid...
-
Page 11: Physical Characteristics
POWER DC Power Consumption 0.65W Max @ 9V DC Current Draw 12mA (without tuner), 66mA (with tuner) Voltage Range 7.5VDC Min – 12VDC Max Power Supply 9VDC with 100mA (or 1Watt) minimum (Recommended – Not included) * IMPORTANT: polarity Pos (+) on outside, Gnd (-) on center. Avg. - Page 12 w w w . l r b a g g s . c o m...