Dc power distribution with fixed & variable outputs (8 pages)
Summary of Contents for Atlas AP-S20
Page 1
AP-S20 Owner’s Manual AC Power Distribution Unit & Surge Suppressor AP-S20 AC Power Distribution Unit & Surge Suppressor 1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A. Telephone: 800.876.3333 • Fax: 800.765.3435 – 1 – AtlasSound.com Specifications are subject to change without notice.
Page 2
AP-S20 Owner’s Manual AC Power Distribution Unit & Surge Suppressor Table of Contents Important Safety Instructions ........................3 Introduction ............................5 Key Features ............................5 Applications ............................5 Front Panel Description ........................... 6 Rear Panel Description ..........................6 Installation .............................. 7 Specifications ............................
Page 3
AP-S20 Owner’s Manual AC Power Distribution Unit & Surge Suppressor Important Safety Instructions The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Page 4
AP-S20 Owner’s Manual AC Power Distribution Unit & Surge Suppressor WARNING When The Device Is In Use • To prevent electric shock, do not remove the product cover as there are high voltage components inside. Refer all servicing to Atlas Sound. • Should any of the following irregularities occur during use, immediately switch off the power, disconnect the power cord from the AC outlet and contact Atlas Sound. Do not to attempt to continue operation with the product as this may cause fire or electric shock: •...
AC Power Distribution Unit & Surge Suppressor Introduction Thank you for purchasing the Atlas Power AP-S20 AC Power Distribution & Surge Suppressor Unit. The AP-S20 has been designed to meet most installation requirements for AC power distribution and equipment power protection.
2. AC Mains Breaker The 120VAC 20A 2500W rated breaker will open if the combined draw of all AC outlets exceeds 20A. Note: The breaker is designed to exceed its rating for a short period of time. If the breaker is tripped, you must first remove the load from the AP-S20 and then push to reset. 3. Power Switch To turn the AP-S20 On or Off, press the switch to the ON or OFF position. This switch powers the “switched” outlets. The switch...
⁄ " x 1". Always make sure the 20A outlet is properly inspected by a certified electrician prior to connecting the AP-S20. Make sure to inspect the equipment that is to be plugged into the AP-S20 to ensure it does not exceed 20A total amperage draw.
This warranty gives you specific legal rights and you may have other rights which vary from state to state. Service Should your AP-S20 require service, please contact the Atlas Sound warranty department at 1-877-689-8055, ext. 277 to obtain an RA number.
Need help?
Do you have a question about the AP-S20 and is the answer not in the manual?
Questions and answers