Operating Instructions; Controling Your Heater - Ambia ACH-120 Owner's Manual

OPERATING INSTRUCTIONS

SITUATING YOUR TWO ZONE HEATER
Your heater has been designed with a variety of use situations in mind. The
two basic uses are:
1. Combined: both heat modules attached to base, used as a single heat
source
2. Separated: each heater module in a different position, connected by the
interconnect tether
COMBINED
Place the heater where desired, taking careful note of the safety guidelines
listed in Section 3 of this manual. Please see the Controlling Your Heater
section for further instructions.
SEPARATED
A unique aspect of your Two Zone Heater is the ability to locate the two
heater modules in separate locations.
To separate the modules:
Lift module, pull away from base.
6
To make routing the
interconnect cord easier,
it can be disconnected
from the base unit, and
reconnected after you've
located the module
where you want it.

CONTROLING YOUR HEATER

Use the power knob to turn
the heater on, and select
which modules you wish to
provide heat.
• Position 1 powers both
units.
• Position 2 powers only the
right module, and
• Position 3 powers only the
left module,
NOTE: When re-attaching the
module to the base, you may
choose from 3 angles.
OFF
7