Summary of Contents for Hamilton Electronics MPC-6060
-
Page 1: Instruction Manual
MPC-6060 PORTABLE MP3/CD PLAYER AM/FM RADIO DOUBLE CASSETTE RECORDER WITH VARIABLE SPEED & REMOTE CONTROL INSTRUCTION MANUAL... -
Page 2: Warnings And Precautions
Warnings and Precautions • CAUTION: TO PREVENT ELECTRIC SHOCK, • WARNING: Lithium batteries, like all rechargeable MATCH WIDE BLADE OF PLUG TO WIDE SLOT, batteries are recyclable and should be recycled or dis- FULLY INSERT. posed of in normal household waste. Contact your local government for disposal or recycling practices in your •... -
Page 3: Important Safety Instructions
Important Safety Instructions Read these Instructions. FCC Warnings General Keep these Instructions. NOTE: This equipment has been tested and found to comply with Power supply: AC 110V / 60Hz Heed all Warnings. the limits for a Class B digital device, pursuant to Part 15 of the DC 12V (Uses 6 pcs of “UM-1”... -
Page 4: Connecting The Power
Headphone Connecting the Power Turn the unit volume to minimum before you connect your headphone to headphone jack. Headphones should have a 3.5 mm diameter stereo plug and an impedance of 8-32 ohms. When headphones are AC POWER OPERATION connected, the speakers automatically get disconnected. Before connecting the unit to an AC Outlet, check that the operating VOLTAGE of the unit is identical with the NOTE: Extended listening of music at high volume may damage your hearing. -
Page 5: Cassette Operation
Cassette Operation Location of Controls 10. Adjust the VOLUME, if necessary. 11. To stop recording, press STOP/EJECT button. When the playing tape reaches the end of recording it be stopped automatically. CD SPEED knob Note: If echo effect function is used during recording, the echo effect will be recorded. HEADPHONES jack SPEAKER BALANCE knob OPERATION RECORDING... -
Page 6: Radio Operation
Radio Operation CD Operation To Program Specific Tracks (up to 20 Tracks for CD and 99 Tracks for MP3) 1. Slide the FUNCTION switch to “RADIO” position. 2. Slide the BAND switch to your desired band position. 1. Load the CD you wish to program. Make sure the unit is in the “STOP” mode. 3.