HOLOPHANE HARP SERIES Installation And Maintenance Manual

HOLOPHANE HOLOPHANE
HOLOPHANE HOLOPHANE
AFTER INSTALLATION DELIVER THIS
MANUAL TO OWNER
3" X 4" Tall Tenon Mount Version

IMPORTANT SAFETY INSTRUCTIONS

WARNING
– READ THESE INSTRUCTIONS
CAREFULLY BEFORE ATTEMPTING TO INSTALL OR
MAINTAIN THIS FIXTURE. WORK MUST BE DONE BY
QUALIFIED PERSONNEL.
WARNING
– BE CERTAIN THAT ALL ELECTRICAL
POWER IS DISCONNECTED
FROM THE FIXTURE BEFORE INSTALLING
OR MAINTAINING THE FIXTURE.
WARNING
– FOLLOW LAMP MANUFACTURER'S
OPERATING AND MAINTENANCE INSTRUCTIONS.
FAILURE TO FOLLOW THESE WARNINGS
MAY RESULT IN DEATH, INJURY OR SIGNIFICANT
PROPERTY
1. INTRODUCTION
1.1 Product Description.
•
The Harp luminaires have been designed to distribute specific
patterns of light on the surface below. All optics have street side
orientation embossed on the flange of the refractor.
•
The Harp luminaire is designed for easy maintenance.
•
The lamp can be easily accessed by loosening a screw and
swinging down the refractor.
•
Electrical components are mounted on an easily removable
ballast assembly plate.
®
HARP SERIES
DAMAGE.
Installation and
2" Threaded Pipe Mount Version
1.2 Alternate Information Sources.
Holophane
Field Service Department
P.O. Box 3004
Newark, OH 43058-3004
(866) 759-1577
2. INSTALLATION
2.1 Tools and Material Required.
Table 1. Installation Tools and Materials
DESCRIPTION USE
1/8" hex wrench Set screws (mounting)
3/8" nutdriver or medium
flat screwdriver
Torque wrench
7/16" nutdriver or socket
1/4" nutdriver or medium
flat screwdriver
2.2 Fixture Installation.
2.2.1
Feed supply leads from the pole through the wireway hole
2.2.2
Place and level the luminaire on the pole. On units that
mount to a 3"O.D. X 4" tall tenon, alternately tighten the (6) set
screws to 10-12 foot pounds. See Figure 1. On units that mount
to a 2" threaded pipe, install the pipe nut (not supplied) used to
secure the unit.
Maintenance
Manual
GR892, GR1074
Ballast assembly plate
and wireway cover
Set screws
Ballast Assembly Cover
Ballast assembly Plate
IM-136-B