Advertisement
Quick Links
Mounting Template
Two #8 wood screws are required to mount the unit either vertically or
horizontally. Use this page as a template for determining screw locations.
Leave 1/2 inch (1.3 cm) of the screw head exposed; you can then slide the base
of the unit directly onto the screw heads for mounting.
Horizontal Mount 4.5 in./11.43 cm
Vertical Mount 3.0 in./7.62 cm
center to center
This product includes software developed by the University of California, Berkeley and its contributors. This
product includes cryptographic software written by Eric Young (eay@cryptsoft.com).
Copyright 2005 by Hypercom Corporation. All Rights Reserved. Hypercom and the Hypercom logo are registered
trademarks of Hypercom Corporation. IN-tact is a trademark of Hypercom Corporation.
center to center
940475-001, Rev B
í~Åí=
fkJ
NOMO
»
fåëí~ää~íáçå=dìáÇÉ
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Hypercom IN-tact 1202
Summary of Contents for Hypercom IN-tact 1202
- Page 1 This product includes software developed by the University of California, Berkeley and its contributors. This product includes cryptographic software written by Eric Young (eay@cryptsoft.com). Copyright 2005 by Hypercom Corporation. All Rights Reserved. Hypercom and the Hypercom logo are registered trademarks of Hypercom Corporation. IN-tact is a trademark of Hypercom Corporation.
- Page 2 The unit powers on upon connection; there is no power switch. Check the LEDs 1. After connecting the IN-tact 1202 unit, check the power LED on the front panel. It should now be glowing green, indicating that the unit is powered on.
Need help?
Do you have a question about the IN-tact 1202 and is the answer not in the manual?
Questions and answers