Table of Contents
Advertisement
6
I
nstallation
Connect the drain hose
G
Connect the drain hose to the
outlet of the drain pump located
at the rear of the washing
machine.
❏ NOTE
:
G
Never lay down the drain hose, as water will be discharged.
G
Be sure the drain hose is properly routed so it will not kink or lift from the sink.
G
To prevent syphoning, the drain hose should not extend more than 50 mm
from the end of the hose guide.
G
The discharge height should be approximately 0.9~1.2m from the floor.
✽
" Washing machine is to be connected to the water mains using new hose-sets and that old hose-sets should not be
reused "
Flooding drainage
G
Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL FLOW of any
water that may leak out should the machine malfunction.
It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with a drain hole
(or slope) that will prevent any possibility of water damage to floor coverings or property.
Connect the inlet hose
G
Check that sealing washers are firmly seated.
G
Attach the curved end of the hose to the inlet valve of the washing
machine; Tighten the coupling nuts securely by hand. (Fig. 1)
G
Attach the straight end of the hose to the tap.
Tighten the coupling nuts securely by hand. (Fig. 2)
G
Another hose can be attached to hot inlet valve and tap.
G
Turn on the taps and check for leaks. Tighten the coupling nuts firmly
if there is any leakage. If water pressure is strong, close the water tap
completely then open it slightly.
CAUTION
G
Attach the clip to the drain hose. And
then push it toward the body of the
washing machine as
indicated by the arrow.
G
Do not install the washer where it is directly exposed to sunlight, wind, rain etc.
G
Plug the power cord of this washer into a properly installed standard power point that is switched & earthed.
G
Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL
FLOW of any water that may leak out should the machine malfunction.
It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with
a drain hole (or slope) that will prevent any possibility of water damage to floor coverings or property.
G
Permissible water temperature : Max 70°C(160°F)
G
Permissible water pressure : Max 80psi (550kpa, 8kg/cm
G
If water temperature & pressure is greater than above, it may cause damage to the machine. If you
have uncontrolled water temperature & pressure you should fit a temperature & pressure relief valve
to ensure that water temperature & water pressure remains within the safe limits. Consult a plumber
or electrician if you are unable to adjust water temperature and pressure.
G
Do not over tighten the coupling nuts with a tool. Inlets are plastic : Do not strip or crossthread.
G
Place the hose guide over the
laundry tub or the stand pipe.
G
Do not use an extension hose.
Within 50mm
Hose Guide
Drain Hose
INLET
VALVE
TAP
SEALING
WASHER
TAP
END
SEALING
WASHER
MACHINE
INLET
END
HOSE
(Fig. 1)
(Fig. 2)
2
), Min 4psi (30kpa, 0.3kg/cm
0.9~1.2m
TWIST
2
)
Hide quick links:
Advertisement
Table of Contents
