Advantage S1 Owner's Manual page 9

S1 DISC PLAYER
_____________________________________________________________________
____
3. PLAY/PAUSE
This dual-function button alternates between starting and stopping playback. Press to
start play or to resume play after pause. During play, press this button to stop playback
temporarily, keeping the laser at its current position on the disc.
The play mode is identified by the "4" icon in the display. In the pause mode, the ";"
icon is displayed instead.
To resume playback at the exact point where it stopped, press PLAY/PAUSE again. If
you don't want to resume play at the same point, you may use the SKIP controls to cue
the pickup to a different starting point before pressing PLAY/PAUSE again.
4. SKIP Forward :and SCAN Forward
The : functions are combined in one SKIP/SCAN Forward button. During play, pressing
SKIP Forward : will jump to the beginning of the next track and resume play there.
Thus, to sample each song on a disc, press PLAY/PAUSE and then tap SKIP Forward :
after you've heard a few seconds of each track.
If you try to SKIP Forward past the last track on the disc the player will play the last track
on the disc.
The SCAN Forward function is activated by pressing the same button, but keeping it
depressed for more than 1 second. This causes the laser to scan rapidly forward through
the music. The behaviour of this function is similar to SCAN Back.
If you scan forward to the end of the disc while playing the final track, the scan will stop
and the display will show "-OVER-". When you let go of the button, the player switches to
STOP mode.
5. MENU
This button cycles through the different options and settings that can be programmed on
the player
6. VOLUME –
By pressing this button you lower the volume from the player.
7. VOLUME +
By pressing this button you lower the volume from the player.
Observe:
These two buttons are only active when the player is set to Volume control enabled.
Read more about this function in "Programming your S1"
8. DIM/STANDBY
If you press this button briefly you can switch the displays on and off. When you are in
"OFF" mode the player will show all changes briefly before shutting the display again (i.e.
changing volume setting, skipping etc.)
If you press this button for more than a second the player switches off to standby mode.
Press again to switch it on.
For best results, the S-1 should be left on or in the standby mode at all times. The unit
should not be switched off via the master ON/OFF switch unless the unit will not be used
for
a significant period of time (during vacations, etc.).
___________________________________________________________________
_____
Page 8