Whirlpool 30” Installation Instructions page 4

5.
Numbers
correspond
to steps.
5
Make elecir~cal connection See
m Electrlcol requirements and
ElectrIcal connectlon sechons. Panel A
for detorls
6
Center CNen IntO
n cabrnet cutout Secure
o"e" to coblnef "srng screws through
the mOu"lI"g holes I" the front frame of
the oven
Replace oven door by frflrng both
corners of door over ends of hinges.
Push door evenly and completely onto
hrnges Remove norIs from hinges
Reinstall ho screws mto
inner
door
panel If door does no1 close, you have
no1 pushed door completely onto
hinges
Check the operatron of the oven. Set the
oven selector swatch to "Bake." Set the
oven temperature control knob to 350°F
The bottom element should glow red.
Both oven rndrcator lrghts should be on
and the oven should be heotrng The
upper element should become hot but
not glow red
Check the operation of the brorl
element Set the oven selector and
temperature control lo broil. The top
element should glow red Both oven
rndicator lights should be on and the
oven should be heating
Gutde. Keep lnrlatlatlon Instructions
w
Panel c