Table of Contents
Advertisement
12-2158.fm Page 7 Wednesday, September 13, 2000 1:50 PM
5. Connect the green wire to the left rear
speaker's positive terminal.
6. Connect the green/black wire to the left
rear speaker's negative terminal.
7. Connect the violet wire to the right rear
speaker's positive terminal.
8. Connect the violet/black wire to the right
rear speaker's negative terminal.
To connect the harness to one pair of speak-
ers:
1. Connect the gray wire to the right
speaker's positive terminal.
2. Connect the violet/black wire to the right
speaker's negative terminal.
3. Connect the white wire to the left
speaker's positive terminal.
4. Connect the green/black wire to the left
speaker's negative terminal.
Completing the Connection
Connect the vehicle's antenna cable to the
CD player's antenna connector at the back of
the unit.
Make sure you have securely made all the
connections described in the preceding sec-
tions, then plug the harness connector into
the CD player's 14-pin wiring socket. Recon-
nect the cable to the vehicle's negative (–)
battery terminal.
Testing the Connections
Reset your CD player's display (see "Reset-
ting the Display" on Page 11), then install
your CD player's control panel (see "Install-
ing/Removing
the
Control
Page 10). The display should light, and you
should hear a station through the speakers
when you play the radio (see "Radio Opera-
tion" on Page 11).
If the display does not light and you do not
hear a station, immediately turn off your
vehicle's ignition and disconnect your ve-
hicle battery's negative (–) cable. Then re-
check your connections.
After you verify that the display lights and
you hear a station, follow the instructions in
"Mounting the CD Player."
Caution: If you played a CD while testing the
connections, be sure to remove the CD from
the CD Player before continuing.
MOUNTING THE CD PLAYER
Be sure you verify that the CD player is con-
nected properly (see "Testing the Connec-
tions" on Page 7) before mounting in the
dash.
1. Make sure the ignition is turned off, then
disconnect the cable from the vehicle's
negative (–) battery terminal.
2. Disconnect the 14-wire harness and dis-
connect the antenna.
3. Press
the control panel to remove the control
panel.
Panel"
on
Installation
on the upper right corner of
REL
REL
7
Advertisement
Table of Contents
