Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for D-MAX DRX-500
- Page 1 CCTV RECEIVER USER MANUAL DRX-500 DONGYANG UNITECH...
- Page 2 WARNING Always have the unit installed by the store it was purchased from. Improper connections and/or installation could result in electrical shock, fire or other serious injury or damage. Do not place the unit on an unstable surface. Always checks the strength and stability of the installation location. A falling unit will result in damage and could cause serious injury.
- Page 3 CAUTION Always use the unit indoors. The unit should never be used outdoors, or in any place where it will be exposed to rain or other extremes of moisture. Direct exposure to water will result in rust and will damage the unit. Never use in environments that have heavy concentrations of dust, smoke, steam or humidity.
-
Page 4: Table Of Contents
T able of Content CHAPTER1. INTRODUCTION 1. FEATURES CHAPTER2. CONNECTIONS 1. NAMES AND FUNCTIONS OF EACH PART 2. HOW TO CONNECT TO PERIPHERALS CHAPTER3. HOW TO USE THE DETAILED FUNCTIONS 1. RS485 CONNECTION 2. RS422 CONNECTION 3. ADDRESS SETTING CHAPTER4. NOTICE 1. -
Page 5: Chapter1. Introduction
CHAPTER1. INTRODUCTION 1. FEATURES 1-1. Controlling through Data Communication Data communication with the controller allows this receiver to control Pan/Tilt, Zoom Lens, Camera, Light Power, etc. 1-2. Supports Various Communicating Standards. This receiver covers various communicating methods of RS485, RS422, TTL. 1-3. -
Page 6: Chapter2. Connections
CHAPTER2. CONNECTIONS 1. NAMES AND FUNCTIONS OF EACH PART ADDRESS/INITIAL SW AC IN DIP SW 110V 220V INPUT AC24V PT POWER SEL DATA INPUT 485(+) 422 IN 485(-) 522 IN 422(+) OUT 422(-) OUT POWER 485/422 SEL RS422/485 DOWN LEFT RIGHT A/PAN ZOOM... - Page 7 ④ AC110/220 Converting Switch Choose suitable kind of Power Sources with this switch. ⑤ P/T POWER SELECT Can choose suitable kind of Pan/Tilt-activating power. AC110V, AC220V and AC24V are available. ⑥ TTL/485(422) SELECT Insert the socket to the pin on your demand. If your socket covers the pin beside which 'RS422/485' is written, you choose 485/422 way ⑦...
-
Page 8: How To Connect To Peripherals
2. HOW TO CONNECT TO PERIPHERALS □ Basic Diagram of Line Connection LIGHT POWER CAMERA POWER ADDRESS/INITIAL SW AC IN DOWN DIP SW LEFT RIGHT AUTO PAN P/T COMMON 110V 220V INPUT AC24V PT POWER SEL DATA INPUT 485(+) 422 IN 485(-) 522 IN 422(+) OUT... -
Page 9: Chapter3. How To Use The Detailed Functions
CHAPTER3. HOW TO USE THE DETAILED FUNCTIONS 1. RS485 CONNECTION Used when the RS485 mode is chosen in the Junction Box. Shielded Twist Paired Cable is recommended. In case of using AWG28 cable, this receiver can send the data up to 1.2Km away. -
Page 10: Rs422 Connection
2. RS422 CONNECTION Used when the RS422 mode is chosen in the Junction Box. Shielded Twist Paired Cable is recommended. In Case of using AWG28 Cable, this receiver can send the data up to 1.2Km away. (It may differs from real spots) DATA INPUT 485(+) 422 IN... -
Page 11: Address Setting
3. ADDRESS SETTING 1. Set the addresses with DIP switches numbered 1~8. You can use up to 255 receivers (cameras) with the keyboard controller (DCK-255). 2. You must turn off the switches of No. 9 and 10 if you are using the 'DCK-255' controller together. -
Page 12: Chapter4. Notice
* If you turn on NO.7 DIP S/W, NO.1 in above Table will be NO.65 and NO.64 in above table will be set for NO.128. And if you turn off NO.7 DIP S/W and turn on NO.8 DIP S/W, NO.1 in above Table will be NO.129. And if you turn on both NO. 7 and 8 DIP switches, NO.1 in above Table will be the NO.193. -
Page 13: Repairing Measures
2. REPAIRING MEASURES * Check the unit as the following ways when you happen to meet situations mentioned in table. Status Confirmation Management Is the Power supplied Reconnect the Power after Power not supplied normally? confirmation Power is being supplied Is the right fuse and voltage Check the fuse and control the input normally, but the unit doesn't... -
Page 14: Chapter5. Appearance
CHAPTER5. APPEARANCE UNIT: mm 제6장 제품 규격... -
Page 15: Chapter6. Specification
CHAPTER6. SPECIFICATION ● AC 110V/220V, 50/60HZ Power ● 1KW Power Consumption ● RS485/RS422 DATA Async., 1 start bit, 1 stop bit, 8 data bits, No parity, 9600 bps Communicating Method ● NEGATIVE TTL (9V PULL UP) Async., 1 start bit, 1 stop bit, 8 data bits, Even parity, 1200 bps ●...
Need help?
Do you have a question about the DRX-500 and is the answer not in the manual?
Questions and answers