Table of Contents
Advertisement
-~
::..~
"
~
"
...•
"',:;". '! .
.c
..• +:".
INSTALLATION
4. INSTALLATION
Unpack the VSB-70 carefully. Check for signs of damage. If any damage is
noted, contact your dealer or the freight company. Keep any cartons and packing
materials for the ~ealer's inspection. COrl~ider keeping the container and packing
materials in case the unit must be shipped in the future.
The VSB-70 is designed to transmit and receive in the 420 MHz to 440 MHz
range. These instructions are for installation. Operation instructions are given on-
page 7. Complete the installation as follows:
I
Warning!
WarningJj
DO NOT TRANSMIT WITHOUT A LOAD!
The transceiver
must NOT transmit
Into a load with an SWR higher than
1.8:1. Damage may result from transmitting
without
an antenna
or dummy
load •....
'.
1. Connect a coax cable from your 70 em antenna to the BNC ANTENNA con-
nector on the rear panel of the VSB-70.
2. To transmit live video: connect your video camera or Camcorder to the
CAMERA connector on the front panel of the VSB-70. Connect to VIDEO and
AUDIO jacks on the rear panel if a Camcorder with adapters is used. P!Jt
VIDEO/CAMERA
switch in the appropriate position.
I
3. To transmit VCR video: connect your VCR video and audio output signals to
the VIDEO IN and AUDIO in jacks, respectively, on the rear panel. Press
VIDEO/CAMERA
push-button switch to VIDEO (latched out).
4.
Connect your television receiver to the Type F (TV coax) connector on the
rear panel
[NOTE!
NOTE!
I
Your television receiver will display transmit and receive video on channel 3
or 4. The VSB-70 is delivered with the channel 3 jumper installed. To change to
the alternate channel, follow the instructions on page 6.
5.
If your camera does not have a built-in microphone, connect your microphone
to the MIC jack on the front panel.'
6.
If your microphone uses push-to-talk keying, connect the PTT line to the PIT
jack on the front panel.
5
Advertisement
Table of Contents
