Charging Time - Sony Handycam HDR-CX130 Operating Manual

Charging time

Approximate time (min.) required when you fully charge a fully discharged battery pack.
Battery pack
NP-FV50 (supplied)
NP-FV70
NP-FV100
The charging times shown in the table above are measured when charging the camcorder at a
temperature of 25 C (77 °F). It is recommended that you charge the battery in a temperature range of 10
C to 30 C (50 °F to 86 °F).
* The charging times are measured without using the USB Connection support cable.
Tips
¼
See page 61 on recording and playing time.
When your camcorder is on, you can check the approximate amount of remaining battery power with the
remaining battery indicator at the upper right on the LCD screen.
To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever (
pack ( ).
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step 1: Charging the battery pack" (p. 13). Even if the battery
pack is attached, the battery pack is not discharged.
Notes on the battery pack
When you remove the battery pack or disconnect the AC Adaptor, turn the camcorder off and make sure
that the (Movie)/
The CHG (charge) lamp flashes during charging under the following conditions:
The battery pack is not attached correctly.
The battery pack is damaged.
The temperature of the battery pack is low.
Remove the battery pack from your camcorder and put it in a warm place.
The temperature of the battery pack is high.
Remove the battery pack from your camcorder and put it in a cool place.
AC Adaptor
155
195
390
(Photo) lamps (p. 24), the access lamp (p. 22) are turned off.
Charging time
Built-in USB Cable
315
600
1050
) and remove the battery
*
US
15