Locknut - Husqvarna LT130 Owner's Manual

TO ATTACH NOSE ROLLER (See Fig. 4)
• Position brackets, 17/32 x 7/8 x 16 gauge washers, and
nose roller between deck mounting brackets as shown.
Be sure to position brackets on correct side, as shown.
• Install 3/8-16 x 1 hex bolts and 3/8-16 crownlock nuts
as shown. Tighten hardware securely.
NOTE: Be sure bracket tabs are positioned in tab holes in
deck brackets.
TAB HOLE
NOSE ROLLER
HEX
BOLT
"B"
BRACKET
TAB
ASSEMBLE GAUGE WHEELS TO MOWER
DECK (See Fig. 6)
Assemble gauge wheels with tractor on a flat level surface.
• Adjust mower to desired cutting height (See "TO AD-
JUST MOWER CUTTING HEIGHT" in the Operation
section of this manual).
• With mower in desired height of cut position, gauge
wheels should be assembled so they are slightly off the
ground. Install gauge wheel in appropriate hole with
shoulder bolt, 17/32 washer, 3/8 washer, and 3/8-16
locknut and tighten securely.
• Repeat for opposite side installing gauge wheel in
same adjustment hole.
GAUGE
WHEEL
MOUNTING
BRACKET
3/8-16

LOCKNUT

3/8 WASHER
GAUGE WHEEL
ASSEMBLY
"A" BRACKET TAB
CROWNLOCK
NUT
WASHER
FIG. 5
17/32 WASHER
SHOULDER
BOLT
FIG. 6
INSTALL MULCHER PLATE
(See Figs. 7 and 8)
• Install two latch hooks to mulcher plate using screw,
washer, lock washer, and weld nut as shown.
NOTE: Pre-assemble weld nut to latch hook by inserting
weld nut from the top with hook pointing down.
• Tighten hardware securely.
• Raise and hold deflector shield in upright position.
• Place front of mulcher plate over front of mower deck
opening and slide into place, as shown.
• Hook front latch into hole on front of mower deck.
• Hook rear latch into hole on back of mower deck.
CAUTION: Do not remove discharge
guard from mower. Raise and hold
guard when attaching mulcher plate
and allow it to rest on plate while in
operation.
WELD NUT FROM THE TOP
LOCK
WASHER
WELD
NUT
SCREW
LATCH
HOOK
WASHER
MULCHER
PLATE
8
HOOK POINTS DOWN
LATCH
HOOK
WELD
NUT
LOCK
WASHER
WASHER
SCREW
FIG. 7