Table of Contents
Advertisement
ECG
®
WSS-1
Installation:
Attach the antenna to the antenna plug at the back of the camera
by screwing it in place. Then place the camera on a flat, stable
surface.
Connect one of the provided power adapters to the power jack
and then into a power outlet, then slide the power switch to the
ON position. The power indicator will light up and the camera will
calibrate itself by automatically running through its full range of
motions.
Connect one of the provided power adapters to the power jack
of the receiver and then into a power outlet. Then slide the power
switch to the ON position.
NOTE!
This receiver can also work on battery power. Please insert four
(4) AAA batteries into their appropriate slots at the back of the
(Note: It will not charge the batteries.)
- 3 -
Advertisement
Table of Contents
