Canor SH-1 User Manual

Download this manual

CANOR , spol. s r.o., Strojnícka 1, 080 06 Prešov, Slovakia

Tel./Fax: + 421 51 7710 396,

e-mail: canor-audio@canor-audio.com,

http://www.canor-audio.com/

CANOR SH-1 headphone amplifier User Guide

Dear lover of music,

thank you, that you have purchased our CANOR SH-1 headphone amplifier. To preserve and

maintain the best characteristics of your amplifier, we recommend you carefully read the

following lines.

Safety instructions

Please, read before placing the device in action.

1. Read the instructions - all safety information and instructions should be read before using

the amplifier.

2. Keep instructions - security and user instructions should be stored for possible later use.

3. Follow the instructions - all the security and user instructions should be followed.

4. Water and moisture - preamplifier should not be placed near water, for example near the

baths, swimming pool, kitchen sink, etc..

5. Accessories - do not use accessories not recommended by the manufacturer.

6. Location - do not put a device on the fragile backing. The device may fall, which can cause

serious injuries to children or adults, as well as damage to the device. Use only backings or

stands recommended by the manufacturer or sold to dealers at the same time with this device.

Any location of the device should be in accordance with the manufacturer's instructions and

only accessories recommended by the manufacturer should be used.

7. Wall mounting - the device should be mounted on the wall only if the manufacturer

recommends.

8. Ventilation - equipment should be placed so that it guarantees it a good airflow. This means

that it must not lie on the sofa or upholstered furniture, in the working condition it must not be

covered. It would then prevent proper air flow around the vent holes of device.

9. Heat – the device must be located so as to avoid the heating from heat sources, for example

heaters or stoves or other heat-producing equipment. The distance from the rear wall of the

device may not be less than 10 cm, and 20 cm above the area of the amplifier may also be no

obstacle.

Page 1 CANOR SH-1 headphone amplifier User Guide Dear lover of music, thank you, that you have purchased our CANOR SH-1 headphone amplifier. To preserve and maintain the best characteristics of your amplifier, we recommend you carefully read the following lines.
Page 2 10. Power source - the device must be connected only to a power supply, for which it is proposed. 11. Power cord - it is necessary to pay particular attention to a power cord, it must be positioned so as to avoid stepping on it and to ensure it is protected against mechanical damage.
Page 3 Verify that the input signal cables are properly connected. Verify that the three - pole 6,3mm jack from the headphones is plugged deep enough. Caution! Inside your CANOR SH-1 headphone amplifier there are no parts or adjusting features that user can set or correct...