Summary of Contents for EcoTAC Salt-Free Hard Water Conditioner
- Page 1 OWNER’S MANUAL & INSTALLATION GUIDE PLEASE READ THIS MANUAL CAREFULLY BEFORE ATTEMPTING INSTALLATION. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY VOID YOUR WARRANTY.
-
Page 2: Table Of Contents
Congratulations on the purchase of your EcoTAC™ Salt-Free Hard Water Conditioner. You have purchased one of the finest hard water treatment systems on the market today. EcoTAC™ treatment systems use the latest in salt-free hard water conditioning media technology to reduce or eliminate hard water mineral scale. -
Page 3: Operating Conditions
The following chart provides guidance on the conditions required for successful operation of your EcoTAC™ system. Use of this equipment outside of these operating conditions may adversely affect the performance of your system, damage the TAC media, result in system damage including water leaks and resulting property damage, and may void your warranty. -
Page 4: Installation
While we strongly recommend that a licensed plumber perform all installation work, a mechanically-inclined homeowner can install an EcoTAC™ system. In all cases, it is critical that the installation be done in accordance with these instructions and all applicable plumbing codes. -
Page 5: Step 2 - Select An Installation Site
UV light could damage components of the system. In most cases, the EcoTAC™ unit should be located AFTER the expansion tank and all other water treatment devices EXCEPT an ultraviolet (UV) sterilizer (if applicable), and BEFORE the hot water heater. -
Page 6: Step 5 - Install Pre-Filters (If Applicable)
Step 5. – Install Pre-Filters (if applicable) If you purchased pre-filters for your system to remove sediment and/or chlorine or any other contaminants prior to your EcoTAC™ system, you should install them now. Follow the ® instructions that came with your pre-filters. Teflon tape should be the only sealant used on the threaded plumbing connections of the pre-filters. -
Page 7: Step 7 - Complete Plumbing Connections
The outlet should be connected to the side of the valve marked “DOWNFLOW INLET.” The red arrows on the bypass controls indicate the water flow direction for a DOWNFLOW system and should be ignored. The EcoTAC™ is an UPFLOW system. -
Page 8: Step 8 - Initial Start-Up And Leak Testing
If this is the case, be sure to install regulation ground clamps to the metal pipe on each side of the EcoTAC™ unit and connect a jumper wire between the 2 clamps (#4 gauge solid copper wire recommended). Consult a certified electrician or plumber if you are unsure. -
Page 9: What To Expect In The First Few Weeks
EcoTAC™. We recommend that you clean out this material by opening the bottom drain valve on the hot water heater 30 to 60 days after installation of EcoTAC™. Be sure to turn off the electricity to your water heater before draining your tank. Follow the manufacturer’s instructions for draining and flushing the tank. -
Page 10: Maintenance Information
MAINTENANCE INFORMATION The EcoTAC™ media in your system will need to be replaced every 3 to 5 years. Use only genuine EcoTAC™ media for replacement. Use of an alternative media may adversely affect the performance of the system. - Page 11 improper manner or inconsistent with these operating and maintenance instructions; wear or deterioration due to environmental conditions; damage occurring during transit; mishandling; improper storage; incorrect supply of water; tampering or alteration; act of god; or any cause beyond the control of HomePlus Products Inc. The original warranty period does not change in the event of part replacement by HomePlus Products Inc.
Need help?
Do you have a question about the Salt-Free Hard Water Conditioner and is the answer not in the manual?
Questions and answers