With velcro for monitor fixation, and cable strap. *If this Flat Panel Display Package has been purchased together with a TANDBERG Edge Screw kit for table stand and different MXP system, there is no need for this set types of walls; gypsum/wood, concrete, top bracket.
Installation 32" Flat Panel Display Package Connecting Cables DVI-D to HDMI Cable Audio Cable PC Stereo IN Bilde nr 6 AC in HDMI Audio (RGB/DVI) Monitor Configuration Recommended maximum volume on the monitor is 65 out of 100. Source input: HDMI/DVI D13803.06 Page 2...
Wall mount 32" Flat Panel Display Package 2. Use the inlay 1. Lay the monitor on a clean surface, from the monitor mount the speakers. packaging as temporary stand. Mount the wall brackets, using four screws. 3. Bend the bracket into correct shape and 4.
Page 4
Wall mount 32" Flat Panel Display Package 6 A) Wooden pillars (w/gypsum) 6 B) Wooden pillars (w/gypsum) 60 cm center-center. 16 inch center-center. Mount into specified Mount into specified holes with screws only holes with screws only 7 Hook the system onto the wall mount rail. 6 C) Brick/Concrete wall.
Page 5
Table stand 32" Flat Panel Display Package 1. Place monitor onto table stand. 2. Secure the table stand with the six M4x10 Secure the table stand with the six M4x10 screws into assigned holes. Make sure to screw all the way until tight! 3.
Page 6
Table stand 32" Flat Panel Display Package 5. Place Set Top onto bracket. Place bracket and Set Top along edge of monitor 6. Connect cables (see page 2) and fixate in cable straps. 7. This is NOT a floor-standing system. Place the system on a flat and rigid surface or table.