Table of Contents
Advertisement
COLOR TEMP.
Item
R DRIVE, G DRIVE,
B DRIVE
R CUT OFF, G CUT OFF,
B CUT OFF
sub menu
reset
NOTE
• Adjust the color temperature after selecting color temperature (HIGH, MID., LOW, or OTHER) on the main menu (see "PICTURE SETTING" on page
21).
NO SYNC FUNCTION
Item
NO SYNC DISPLAY
DELAY TIME
reset
REMOTE SYSTEM
Item
REMOTE IN SEL.
CNT. RJ45 OUT
CNT. RJ45 IN
PORT F1 – PORT F5
reset
NOTE
• For details about external control, see pages 33 to 37.
SECURITY LOCK
Item
SECURITY LOCK
PASS ID SETTING
NOTE
• For details about the Security Lock, see page 32.
To do
Adjusts the drive level of each color (red, green, and blue).
Adjusts the cut-off point of each color (red, green, and blue).
Displays the adjustment bar which enables you to adjust the drive level and cut-off point while
viewing the actual picture.
Restores the default setting for all the items in "COLOR TEMP. "
To do
Selects the screen color (or sleep mode) when no signal is being
input.
Sets the time to change the screen color (or sleep mode) set in
"NO SYNC DISPLAY" above after signals stops being input.
Restores the default setting for all the items in "NO SYNC FUNCTION. "
To do
Selects the input terminal used for external control.
Selects the external control method for RS-485 OUT terminal.
Selects the external control method for RS-485 IN terminal.
Assigns the control function to the RS-485 IN terminal's pins (1 to
5) when selecting "SET" in "CNT. RJ45 IN" above.
Restores the default setting for all the items in "REMOTE SYSTEM. "
To do
Activates/deactivates the Security Lock. When this function is
activated, the monitor cannot be turned on without entering the
password set in "PASS ID SETTING" below.
Sets the password for the Security Lock.
Setting value
MIN += 000 += MAX (in
512 grades)
MIN += 000 += MAX (in
512 grades)
Setting value
OFF, SLEEP (sleep mode),
RED, GREEN, BLUE, GRAY
5s, 1min., 30min.
Setting value
D-sub9, RJ-45
RS485, IR OUT
RS485, MAKE, TRIG., SET
INP. A – INP. F, POWER,
ASPECT, MUTING, PIP, PBP,
– – – (no function)
Setting value
ON, OFF
4 characters
27
Advertisement
Table of Contents
