User manual IMPORTANT SAFETY INSTRUCTIONS Read these instructions. Keep these Instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
User manual Water and Moisture : Do not use this monitor near water for example, near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool and the like wet basement or near a swimming pool and the like. 8.
Page 4
User manual 18.Replacement Parts : When replacement parts are required, radio/television technician for additional suggestions. be sure the service technician has used replacement parts You may find the booklet called how to Identify and specified by AASSET or have the same characteristics as Resolve Radio/TV Interference Problems helpful.
User manual Contents IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFEGUARDS Contents Unpacking Names and Functions of Parts Connecting to External Devices Setup Menu Configurations Appendix Troubleshooting Guide WEEE Symbols - 5 -...
User manual Unpacking 7. IR Sensor Remove the package cover and place the product on a flat and Remote controller sensor. secure surface or in the installation location. Check whether all the following devices and accessories are. 8. POWER ON/OFF included with the main system.
User manual Remote Controller 13. SOURCE Select VGA or Video (Video A / Video B / S-Video) sources. 14. ENTER Select OSD main menu or sub menu. Connecting to External Devices The product can be connected to an external device such as Camera, DVR,VCR, etc.
Page 8
User manual - PAL input Inputs can be set to Video A, Video B, S-Video, VGA mode. 1. Press the MENU button and then button to select the Input menu. ▲/▼ 2. Press the ENTER or button to select the Source List. ▶...
Page 9
User manual 1. Press the MENU button and then button to select ▲/▼ the Picture menu. 2. Press the ENTER or button to select the Adjustment. ▶ 3. Press the ENTER or button and then button to select ▶ ▼/▲ 4.
Page 10
User manual Language Change the system id. (Factory default is ‘1’) 1. Press the MENU button and then button to select the ▲/▼ OSD menu. 2. Press the ENTER or ▶ button and then Press the ▲/▼ button to select the Language. 3.
Page 11
Auto Adjustment. 3. Press the ENTER or▶ button and then Press the button to select the Cancel or Ok. ▲/▼_ Model Name PAC-171AV Composite 2ch input 1.0Vp-p, 75Ω terminated, loop-through out Video S-VIDEO input (Y/C) , loop-through out...