Table of Contents
Advertisement
19-1125.fm Page 24 Tuesday, August 3, 1999 9:47 AM
TRANSMITTING
Caution: It is illegal to transmit if you do not have a Technician Class (or
higher) license issued by the FCC.
!
1. Select the desired frequency.
2. Press LOW so LOW appears on the display. This selects the low
3. Press the push-to-talk button on the side of the microphone to
Notes:
•
•
Transmitting DTMF Tones
To transmit DTMF tones, follow the steps for transmitting. While holding
down the push-to-talk button, press the digits on the microphone to trans-
mit the tones.
Note: If auto-reply is turned on, you must hold down push-to-talk while you
transmit. If auto-reply is off, you can release push-to-talk after you enter
the first digit. The HTX-212 transmits for 1 second after you enter the last
digit. See "Using Auto-Reply" on Page 33.
24
Note: If you select a repeater frequency, the HTX-212 displays + or
– to show the offset direction. To operate with no offset (simplex) on
that frequency, press SHIFT until neither + nor – appears.
power (10 watt) setting.
transmit. The signal strength meter shows half-scale for low power
(or full-scale for high power). Release the push-to-talk button to lis-
ten for a reply.
If the other party advises you to improve your signal, press LOW.
HIGH appears on the display, and the HTX-212 transmits at high
power (about 45 watts).
If you try to transmit outside the permitted range (144.600 to
148.000 MHz default or 143.000 to 149.000 MHz if you extend the
range), the HTX-212 displays tF Err and beeps twice.
Hide quick links:
Advertisement
Table of Contents
