Replacing The Plinth Filter - Miele TMG 440 WP Operating Instructions Manual

Cleaning and care

Replacing the plinth filter

 Fit the filter back on the handle. Make
sure it is the correct way round.
To ensure that the filter is positioned
correctly in the front of the heat
exchanger unit:
 First insert the handle with the plinth
filter attached over the two guide
pins.
– The word Miele on the handle must
be the correct way up.
 Push the plinth filter in completely.
The act of pushing in the plinth filter will
also push in the right hand guide pin.
44
 Close the heat exchanger access
panel.

The dryer can only be operated
with the plinth filter fitted correctly
and the heat exchanger access
panel closed. The access panel must
be closed correctly to ensure that
water cannot leak from the
condenser system and to ensure that
the dryer functions efficiently.