2 Save Energy CM113 User Manual page 14

Setting the cost-per-hour value
Diagram
Setting the greenhouse gas emission per kW rate (see greenhouse gas)
To set the unit and rate of greenhouse gas emissions per electric current production (see greenhouse
gas) follow the instructions below:
Diagram
It may be necessary to change this setting for a product used in the UK, where average greenhouse
NOTE
gas emissions are approximately 1 kilogram per kW. If a precise rate is required, or if you have purchased
a "Green Energy" product, contact your local electricity retailer.
Setting the Battery power save mode
You can save battery power by changing the receiving speed of the Remote Monitor from every 6 seconds
(MAX) to every minute. To change the setting, follow the instructions below:
Diagram
Instructions
1. Press and hold mode for 2 seconds. The first digit of the electricity
cost-per-hour flashes.
2. Use the arrow key to change the flashing value (0-9). Press mode
to set value. Repeat for all digits.
3. Press mode when finished.
Instructions
1. Press mode to change to the Greenhouse Gas display.
2. Press and hold mode for 2 seconds.
3. The Greenhouse Gas emission unit blinks. Use the arrow key to toggle
between units (Kg/Hour or Ton/Year). Press mode to confirm.
4. The Greenhouse Gas value blinks. Use the arrow key to change
the value.
5. Press mode again to return to the Greenhouse gas display.
Instructions
1. When 'MAX' icon is displayed, press and hold the arrow key for 2
seconds.
2. The 'MAX' icon disappears. Repeat these steps to re-enable "MAX'
receiving speed.
4