Advertisement
5. Activate the new sensor by rotating the sensor until you hear a
warbling chirp.
6. When all sensors have been learned, press the ALERT light
briefly (you will hear several short beeps) and the receiver will
resume normal operation or simply wait an additional 60 sec-
onds and the receiver will automatically exit the programming
mode.
Sound Notification for Two or More Sensors:
For each additional sensor learned, the receiver sounds two or more
extra beeps when these sensors are triggered. These additional beeps
indicate the order in which the sensor was learned. The original sen-
sor beeps the one alarm or chime sound when triggered. The second
learned sensor gives two extra beeps before the chime or alarm sound,
the third sensor learned gives three extra beeps, etc . . .
4. Temporally Silencing the Receiver
Sometimes you may wish to silence the receiver for several hours.
For example, perhaps the 5AM-garbage pickup triggers your sensor.
To silence the receiver for up to ten hours:
1. Press and hold the ALERT light until you hear a steady tone.
2. The silenced, "sleep" state is indicated by alternating short blinks
of the red and green lights for ten hours or until reset.
3. To resume normal operation, press the ALERT light again briefly.
NOTE: A power failure will cancel the sleep mode.
Page 5
5. Adjusting the Volume
The receiver has two volume settings for the notification beep. The
receiver is factory set to the highest setting. To lower the volume set-
ting:
Further Problems: Call DesignTech International, Inc. at 1-800-337-4468
and we will be glad to help you through any situations. DO NOT Return this
product to the retailer - DesignTech will warranty any product issues directly.
Driveway Monitor 33370
Driveway Monitor 33370
1. Unplug the power supply and antenna from the receiver.
2. Use a small screwdriver and carefully pry open the receiver case
(often carefully prying the case open at the antenna jack area
works best).
3. When the top of the case is removed, you will notice a small
slide switch between the antenna jack and the power jack.
4. Slide the switch towards the power jack to increase the volume.
5. Slide the switch towards the antenna jack to decrease the vol-
ume.
6. Snap the case back together.
7. Plug in the power supply and antenna.
Lower
Changing the volume level
Volume
Higher
Page 6
Advertisement
