DeWalt DCH213 Instruction Manual page 42

WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories.
Installing and Removing the Battery Pack
(Fig. 4)
WARNING: To reduce the risk of injury, never depress the battery
release button without removing the battery pack. Depressing the
battery release button without removing the battery pack can result in
the battery pack falling out unexpectedly.
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (G) into the tool handle, align the battery
pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is firmly seated in the tool and ensure that it
does not disengage.
To remove the battery pack from the tool, press the release button (H)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
NOTE: Operating temperature of this tool is 19° to 104°F (-7° to
+40°C). Using the tool outside of this temperature range will decrease
the life of the tool.
FIG. 4
G
Shocks – Active Vibration Control (Fig. 2)
For best vibration control, hold the tool with one hand on the main
handle (E) and the other hand on the side handle (A). Apply just enough
pressure so the hammer is approximately mid-stroke. The hammer
only needs enough pressure to engage the internal active vibration
control. Applying too much pressure will not make the tool drill faster
and active vibration control will not engage.
SDS Chuck (Fig. 5)
To insert bit, insert shank of bit about 3/4" (19 mm) into chuck (L).
Push and rotate bit until it locks in place. The bit will be securely held.
To release bit, pull the sleeve (M) back and remove the bit.
FIG. 5
L
H
Drilling
WARNING: To reduce the risk of personal injury, ALWAYS
operate the tool with the side handle properly installed. Failure to do
so may result in the side handle slipping during tool operation and
10
M
A