Bush Hog 2315 Operator's Manual page 21

GG. Note: Refer back to Section 2-1G prior
to folding the wings with the tractor hydraulics.
Fold wings into the transport position and install
transport lock pins and presto pin.
HH. Fasten the wing driveline retaining rings to
the wings sections using 1/2" x 1-1/2" bolts, flat-
washers, lockwashers and nuts. (Figure 5-12)
II. With the wings folded raise the center section
and install stop collars on height adjustment cylinder
to retain in this position.
JJ. Attach the rear belting or rear chains with
3/8" x 1" bolts, flatwashers, lockwashers and nuts.
(Figure 5-16)
FRONT BELTING
A. Compare each front belting (Figure 5-16) to
determine location for installation.
B. Align holes in belting with holes on the front lip
of the cutter. Attach with 3/8" x 1" bolts, flatwashers
and locknuts.
FRONT CHAIN
A. Align holes in chain assembly with the holes in
the front lip of the cutter. Attach with 3/8" x 1-1/4"
bolts, flatwasher, lockwashers and locknuts. (Figure
5-16)
B. Install three links of chain between the front
hitch lugs by installing 3/8" x 5" bolt, chain spacers,
and locknut.
Figure 5-16 Flexible Band / Chain Installation
NOTE:
FLEXIBLE BANDS OR CHAINS
INSTALL IN THE SAME MANNER
EXCEPT FOR THE THREE PIECE
CHAIN SECTIONS AT THE FRONT
CENTER OF THE MACHINE.
SAFETY TOW CHAIN
A. Securely attach tow chain to cutter by looping
hook end of chain around one side member of
tongue and back through large link on opposite end
of chain. (Figure 5-17)
B. Before use, attach loose end of chain to towing
vehicle attaching point such as drawbar or bumper,
etc. Fasten chain back to itself with hook latch.
Figure 5-17 Safety Tow Chain
Spring Loaded
Hook Latch
20
Large Link
Chain