NIKKARI BL-J Instruction Manual

Blower attachment

Advertisement

Quick Links

Explanation in the manual which comes together with your purchased product may differ from your product. Use the manual for reference.
NIKKARI Blower Attachment
BL-J
Instruction Manual
BL-J
For Safe Use of Blower Attachment
● Be sure to read this manual and the split engine (to
be purchased separately) manual to have a good
understanding of the contents before handling the
blower.
● If there is no split engine manual, purchase it from
sales agency.
● Keep this manual and the split engine manual carefully
in a readily accessible location.
Copyright (C) 2010 NIKKARI Co., Ltd. All Rights Reserved
This is a manual downloaded from the web site.
Original Instruction
Contents
Important Information ····························· 2
Warranty and Disclaimer ························· 4
1. Safety ······················································· 5
1.1 Warnings ····························································5
1.2 General Precautions ······································7
1.3 Safety Devices and Protective Guard ············13
1.4 Protective Equipment ································14
1.5 Noise·································································14
1.6 Vibration ·························································14
2. Outline ··················································15
2.2 Specification ··················································16
2.3 Attached Material ·················································16
2.4 Model and Position of Serial No. ··················16
3. Installation and Adjustment ··············17
3.1 Installation Method ····································17
4. Operation ············································20
4.1 Pre-operation Check ··································20
4.2 Start and Stop ···············································21
4.3 Precautions for Operation ························22
4.4
Example of Use ·············································23
4.5 Actions after Operation·····························24
5. Maintenance ······································25
5.1 Maintenance of Blower ·····························25
5.2 Greasing ··························································25
6. Storing ··················································26
7. Waste Disposal ··································27
8. Troubleshooting ·······························28
9. Service after Sales ·····························29
10. Technical data(EN31806) ···············30

Advertisement

Table of Contents
loading

Summary of Contents for NIKKARI BL-J

  • Page 1: Table Of Contents

    ● If there is no split engine manual, purchase it from 8. Troubleshooting ·······························28 sales agency. 9. Service after Sales ·····························29 ● Keep this manual and the split engine manual carefully 10. Technical data(EN31806) ···············30 in a readily accessible location. Copyright (C) 2010 NIKKARI Co., Ltd. All Rights Reserved...
  • Page 2: Important Information

    Do not allow any person who does not understand the contents of this manual to handle this blower. ● Do not take any actions other than those described in this manual. ● Do not make any modifications. If it is modified, the warranty will not cover. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 3 Explanation in the manual which comes together with your purchased product may differ from your product. Use the manual for reference. Important Cautions for Safe Work ● NIKKARI Co., Ltd. (hereinafter referred to as NIKKARI) cannot foresee all the risks in handling the blower. Therefore, also give consideration to general safety measures not stated in this manual, split engine manual, and engine manual to prevent accidents when handling the blower.
  • Page 4: Warranty And Disclaimer

    NIKKARI will repair, free of charge, in accordance with the rules and regulations for the warranty.
  • Page 5: Safety

    Indicates enforcement of actions. Actions to be enforced are de- Enforcement signed into pictorial indication inside the symbol. This action is re- Sign quired to avoid hazard. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 6: Warning Labels

    Physically-harmful carbon monoxide is included in exhaust gases. Do not use at the inadequately ventilated place. Keep persons and animals out of the area within a radius of 15 meters from the blower during operation. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 7: General Precautions

    * If they are not used, it could cause eye injury due to scattering of chips of wood. Wear hearing protective equipment including year mufflers when using the blower. * Hearing loss could be developed due to noise of the engine. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 8 When working near the car or building, keep the things around away from the working area. Cover the immovable thing with the heavy-duty sheets or do not operate at the area. * It could cause the equipment to be damaged by scattering of gravel stone, etc. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 9 * If it is operated continuously for a long time, vibration induced white finger could be developed. Do not scatter any object with a sharp tip. * It could hit your body, resulting in injury. Do not operate the blower in a closed area. * Exhausted gas affects the health. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 10 * If the footing is insecure, an accident due to tripping over or falling could happen. Do not touch the muffler during or after the operation. * The muffler is hot and it could cause burn injury. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 11 * Body, hands or fingers could be severed or objects could be damaged by contact with the blade. Remove obstacles, and watch your step when transporting the blower. * If the footing is insecure, an accident due to tripping over or falling could happen. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 12 * If the kind of fuel or oil or the mixture ratio is not appropriate, the engine could be dam- aged. Do not discard gasoline, oil, or grease into the river, the sea, or the ground. * Otherwise, it could pollute the environment. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 13: Safety Devices And Protective Guard

    In case of an accident or abnormality, the brush cutter can be released from the harness or shoulder harness by using the following safety device (quick release). By pulling the red strap (quick release) [1] of harness, the brush cutter will be released from the harness and fall off. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 14: Protective Equipment

    This will cause swelling pain or nerve paralysis of hands, and there is a risk of affecting the hand. To prevent such problems, do not continuously operate for a long time. Instead, take an appropriate break. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 15: Outline

    Connected to the cutting section. Changes the transmission angle of the power from the power transmission shaft to decelerate. Discharge port Air is discharged. Air inlet Air is sucked. Shaft tube This is a equipment to connect the gear case with the join case. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 16: Specification

    The following is the attached material. ■ Attached Material Instruction manual Pipe cap (this book) 2.4 Model and Position of Serial No. Check the model of your blower on the nameplate attached to the machine body and read the corre- sponding sections. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 17: Installation And Adjustment

    3.1.1 Combination with Split Engine The attachment can be installed only to our approved equipment (shown below). For detail, refer to the table below. Manufacturer Our approved split engines NIKKARI MJ-26K: KAWASAKI TJ27E NIKKARI MJ-35K: KAWASAKI TJ35E NIKKARI Blower Attachment BL-J E3502-0...
  • Page 18 If the knob BT [2] cannot be tightened completely, the positions of the posi- tioning hole [1] and the positioning pin [6] are not matched. Loosen the knob BT [2] for appropriate positioning, and tighten it. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 19 Explanation in the manual which comes together with your purchased product may differ from your product. Use the manual for reference. 3.1.3 Removing Loosen the knob BT [2]. Pull out the shaft tube [3]. Slightly tighten the knob BT [2] so that it will not come off. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 20: Operation

    ● Check if the blower does not move during idling. ● Check if the idling is normal. (e) In addition to the above, perform the steps described in the split engine manual. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 21: Start And Stop

    However, the blower will still move for a while (flywheel effect). It does not immediately stop when the throttle trigger is released. For stopping the engine, refer to “(B) Start/Stop Switch in 1.3.1 Safety Devices (Stop Devices).” NIKKARI Blower Attachment BL-J E3502-0...
  • Page 22: Precautions For Operation

    ● Use a harness so that the blower can be held at the position not to get tired easily. ● To prevent fire disaster, do not use the blower in a place where there are organic sediments or excessive lubricants. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 23: Example Of Use

    Tilt the blower by 5°, and swing it right and left to blow dead leaves or cut grasses on the ground to gather them. Airflow ■Prohibited Matter ● Do not work at the position higher than the waste. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 24: Actions After Operation

    Set the start/stop switch of engine to OFF (O side) to stop the engine. Tighten all the nuts, bolts, and screws other than the ones for adjusting the carburetor. Store the blower according to “6. Storing”. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 25: Maintenance

    For maintenance of the split engine, refer to the split engine manual. Greasing Apply grease of approx. 4g from the grease nipple every 20 hours. Use EPNOC AP2 of JX Nippon Oil & Energy or equiva- lent for greasing. Oilhole plug NIKKARI Blower Attachment BL-J E3502-0...
  • Page 26: Storing

    Keep the engine operated until the carburetor is dried. Stop the engine, and store the blower in the following place. (a) Locked place (b) High place out of reach of children and other unauthorized person (c) Dried and cool dark place NIKKARI Blower Attachment BL-J E3502-0...
  • Page 27: Waste Disposal

    Explanation in the manual which comes together with your purchased product may differ from your product. Use the manual for reference. 7. Waste Disposal For disposal, observe the standards and regulations of your region. If there is any question, contact the sales agency. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 28: Troubleshooting

    Contact the sales agency. not move even if Gear has worn. Contact the sales agency. the engine speed is increased. Contact the sales agency. Lead wire is broken or discon- The blower does nected. not stop. NIKKARI Blower Attachment BL-J E3502-0...
  • Page 29: Service After Sales

    9. Service after Sales For repair, handling method or cleaning, contact the sales agency. ■ Storing Period of Spare Performance Parts NIKKARI will store the spare performance parts for this split attachment for 8 years after they are discon- tinued. Note ● The spare performance parts are those required for maintaining the performance of the split attachment.
  • Page 30: Technical Data(En31806)

    90.3 (in accordance with EN27917) average 83.5 87.3 idling 80.5 92.3 Sound power level racing dB(A) 96.4 99.7 (in accordance with ISO 10884) average 93.5 97.4 Guaranted sound power level dB(A) (in accordance with 2000/14/EC) NIKKARI Blower Attachment BL-J E3502-0...

Table of Contents