System expansion
9
8
7
6
5
1 = Connector for external keyboard
2 = Connector for PS/2 mouse
3 = Connector for loudspeaker
4 = Audio connector
5 = Microphone connector
Connecting serial or parallel devices
Connect the device's data cable to the appropriate port connector.
The serial port is configured by default as COM1. You can configure it as COM2 in
System Setup. The parallel port is configured by default as LPT1. You can configure it
as LPT2 in System Setup.
Connecting an external display
You can connect a VGA, SVGA (Super VGA) or multisync monitor. The notebook's
built-in display controller supports resolutions up to 1024 x 768 with 256 colors. If
you wish to use a resolution greater than 640 x 480, you must load the relevant
display drivers (see the manuals supplied with your display).
Connect the display's video signal cable to the notebook's display connector.
Connect the power cable of the external display to a grounded wall outlet and
switch on the display.
Switch on the notebook.
Configure the display output in Video Setup or by pressing the key combination
+
.
Fn
F12
Select the resolution for the external display.
82
4
3
6 = Serial port connector
7 = Display connector
8 = Parallel port connector
9 = Connector for docking unit
Connecting external devices
A26391-K64-Z100-2-7619
1
2