Toro 74625 Operator's Manual page 50

2
3
4
Figure 57
Mower Decks with 3 Blades
1. Blades side to side
2. Sail area of blade
5. Measure between the outside cutting edges and
the flat surface (Figure 56 and Figure 57). If both
measurements are not within 3/16 inch (5 mm), an
adjustment is required; continue with this procedure.
6. Support the weight of mower deck by placing wood
blocks under the edges of the mower deck.
Note: Avoid placing the supports under any anti-scalp
rollers if present on the mower deck.
7. Move to the left side of the machine. Check if the side
carriage bolt is in the fixed or slotted position (Figure
58).
8. If the side carriage bolt is in the fixed position, remove
the side carriage bolt and side locking nut from the
fixed position and install it into the slotted adjustment
position (Figure 58).
If the bolt is in the slotted position, the carriage bolt
and side locking nut do not need to be removed.
G005278
3
1
2
4
3. Outside cutting edges
4. Measure from the tip of the
blade to the flat surface
here
5
4
1. Hanger bracket
2. Slotted adjustment
position
3. Fixed position
9. Loosen the rear locking nut on the hanger bracket
(Figure 59).
3
4
1. Hanger bracket
2. Rear locking nut
10. Loosen the side locking nut on the hanger bracket just
enough to allow the hanger to be adjusted (Figure 59).
Use the notches on the welded bracket to measure
the amount of adjustment. Each notch surface is
equivalent to 0.25 inch, while a single side is 0.125 inch
(Figure 60). Adjust the height of the mower deck to the
desired height.
50
G015323
1
3
2
Figure 58
4. Side locking nut.
5. Side carriage bolt
1
2
G015324
Figure 59
3. Side locking nut, slotted
position.
4. Adjustment notches