Advertisement
Electrical safety
Class 1 Configuration
The wires in the mains lead are coloured in accordance with the following code:
GREEN/YELLOW: EARTH (E)
BLUE: NEUTRAL (N)
BROWN: LIVE (L)
Class 1 Configuration
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows:
• The wire which is coloured GREEN & YELLOW (or coloured GREEN) must be
connected to the terminal in the plug which is marked with the letter "E" or by the earth
symbol
• The wire which is coloured BLUE (or coloured BLACK) must be connected to the NEUTRAL
terminal which is marked with the letter "N".
• The wire which is coloured BROWN (or coloured RED) must be connected to the LIVE
terminal which is marked with the letter "L".
Always ensure that the Mains Cord is fixed into the plug through the Cord Guard or Cable
Clamp, (plug wiring diagram above), and that the Cord Guard screws are tightened to clamp
the cord (outer sheath and inner coloured wires) into position in the plug. Make sure that
the plug top is also fitted securely.
This appliance must be protected by a 13 Amp fuse in a 13 Amp type (BS1363) plug. Should you
need to replace the fuse, use only a 13Amp ASTA approved BS1362 fuse (13A).
OPERATIONAL GUIDELINES
It is important to ensure the correct Plug Adaptor is used when operating in a country not using
the UK 13 Amp socket system. If in doubt, consult a qualified electrician.
Before use
Please wash the food contact parts thoroughly in warm soapy water. Rinse and dry completely.
The juicer is equipped with a number of safety interlocks that prevent it from being powered up
if it is assembled incorrectly, so please take some time to familiarise yourself with the assembly/
dis-assembly of the machine. It's much easier to do when there is no juice in there!
1. put the machine on flat stable surface and ensure switch is in "0" (off) position
2. Assemble the juice outlet tube (no.9) on filter holder (no.8), then assemble the filter holder
(no.8) on the main housing (no.5) (pic 1)
3. Assemble the stainless steel mesh filter (no.7) on the drive axis evenly, make sure the filter
is assembled properly, try to rotate the filter softly to make it move smoothly. (see the pic2)
4. Put the pulp collector (no.3) into position on left side of the machine.(pic 4)
5. Put the upper housing cover (no.2) on the main housing (no.5), use left hand to press the
cover and right hand to bring the lock arm into position. (pic 5)
6. Put the juice collector in position, and then connect juicer to mains supply
7. Your juicer is now ready for use. (pic5)
(PIC1)
(PIC2)
(PIC4)
NOTE: all food should be completely clean before juicing.
As a general rule, only put through fruit or vegetable material that you would normally eat.
For example: you wouldn't normally eat orange peel, so peel oranges before putting them
through. the juicer
BANANAS CAN'T BE JUICED DUE TO THEIR STRUCTURE
(PIC3)
(PIC5)
Advertisement
