Loading Batteries - Moultrie 35mm Instruction Manual

60045_10504_pg.8.pdf

LOADING BATTERIES

9 Volt Batteries for Control Box
Open the control box by swinging the Control Box Latches (11)
open. Insert two fresh 9V alkaline batteries into the 9V Battery
Holders (20). Make sure that the + or - on the batteries match
the + or - indicated in the 9V Battery Holders (20). Make sure
the batteries are secured in their holders.
AA Batteries for Camera
Open the Battery Chamber (25) by sliding the latch in the
direction indicated by the mark on the cover. Place 2 AA
alkaline batteries into the Battery Chamber (25). Make sure
that the + or - on the batteries match the + or - indicated on the
battery chamber door. Close the battery chamber door. Make
sure it is closed securely.
Back-up Power Supply for Camera
Your wildlife camera system also comes with an additional
power supply for long camera life. Insert six fresh AA alkaline
batteries into the Camera Back-up Battery Holders (27). Make
sure that the + or - on the batteries match the + or - indicated in
the Camera Back-up Battery Holders (27). When using back-
up battery holders, alkaline batteries must always be installed.
CAUTION! Always use alkaline batteries, NEVER
rechargeable. Rechargeable batteries may damage circuitry
and void your warranty.
page 8