E-Mu 202 Owner's Manual page 18

Tutorials
18
6. Select Device Setup... from the Devices menu.
7. Select VST Multitrack from the Devices list.
8. In the Setup section of the dialog box, select ASIO E-MU 0202|USB. A pop up
dialog box asks, if you want to keep or switch the ASIO driver. Select Switch.
Buffer Latency Setting
9. Click the Control Panel button.
The pop-up dialog box shown at
right appears.
10. Set the ASIO Buffer Latency as low
as your computer will allow and
click OK.
(10ms is a good starting point.)
A low latency setting is important to
assure fast response when using vir-
tual instruments and to minimize
delay when monitoring through Cubase. If you hear crackles or other audio
problems, try increasing the Buffer Size.
11. Close the Device Setup screen by clicking OK.
12. Note: If the Cubase LE application crashes for any reason, it is recommended
that you re-boot the computer.
13. Select Project Setup from the Project menu. This is where you set the Sample
Rate and Record Format (bit depth), among other things. Set the Record
Format to 24-bits and the Sample Rate to 44.1kHz.
E-MU Systems