Maintenance; Filter; Easy To Replace Filter; Installation - Husky HV02000 Operator's Manual

SP6689-2 Husky HV0200_ES.qxd

Filter

Your filter should be cleaned often to
maintain peak vac performance.
NOTE: The filter is made of high quality
material designed to stop small particles
such as sawdust. Handle the filter
carefully when removing to clean or
installing a new filter. Do not tear the filter
during removal or installation if your
intent is to reuse the filter.

Easy to Replace Filter

1. Extend the retainer band around the
plastic posts on the lid.
2. Remove filter bag off the filter cage.
3. Place the replacement filter on the filter
cage until open end touches bottom of
lid.
4. Release the retainer band from the
plastic post on the lid, holding the filter
bag secure to the lid.
5. Make sure the retainer band is
positioned on the filter bag covering the
black printed line.
Retainer
Band
Lid
Power Head
(upside-down)
4/18/08 3:48 PM Page 10

Maintenance

IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the vac for dry
material pick-up.
Take the dirty filter to a disposal container
and gently brush away small dirt particles
that may be adhering to the filter material.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use
a filter with holes or tears in it. Even a
small hole can allow a lot of dust to come
out of your vac. Replace it immediately.

Installation

Before installing the filter on the vac,
clean the area of the lid so that the
retainer band will seal the bag against the
lid and stop small particles from
bypassing the filter bag.
If the filter is clean and not damaged,
replace it on the filter cage. If it cannot be
reused, place a new filter over the filter
cage.
Replace the retainer band around the
filter. Make sure the retainer band is
positioned on the filter, and the filter
completely covers the filter cage. Also,
make sure the edges of the filter are
completely secured under the retainer
band.
NOTE: Clean the filter in an open area.
Cleaning should be done outdoors and
not in the living quarters.
WARNING: Do not remove the
!
filter cage and float. The float
prevents liquid from entering the
impeller and damaging the motor.
Plastic
Post
The cage prevents fingers from
touching the moving impeller.
10