(W1) Spark Plugs - Blizzard 1980 Bombardier 5500 ski-doo Operator's Manual

Ski
Wash or brush all dirt or rust accumu-
lation from the skis and springs.
Grease the ski legs at the grease fit-
tings. Check the condition of the skis,
ski runners and leaf springs. Replace if
worn or weak.
Controls
Lubricate the steering mechanism. In-
spect all components for tightness,
lspring coupler bolts, steering arm
locking bolts, tie rods, ball joints,
etc.l,
Tighten if necessary. Oil moving joints
of the brake mechanism.
A
WARNING: Do not lubricate the
.... throttle and/or brake cables
and housings. Avoid getting oil on the
brake pads.
Coat all electrical connections and
switches with a greaseless metal pro-
tector. If unavailable, use petroleum
jelly.
Chaincase
Drain the chaincase and refill to proper
level, using fresh chaincase oil. To
drain, remove the chaincase cover.
Fuel Tank
Remove the cap then using a syphon,
remove the gasoline from tank.
A
WARNING: Gasoline is flamma-
.... ble and explosive under certain
conditions. Always perform procedu res
in a well ventilated area. Do not smoke
or allow open flames
or
sparks in the
vicinity.
Carburetor
Carburetors must be dried out comple-
tely to prevent gum formation during
the storage period.
Once the fuel tank is emptied, remove
the float chamber drain plug on each
carburetor. Drain carburetors.
Re-install plug and connect fuel line.
Cylinder Lubrication
Engine internal parts must be lubricat-
ed to protect cylinder walls from possi-
ble rust formation during the storage
period.
O
NOTE: This operation should be
repeated every 40 days during
storage.
Remove the spark plugs. Operate the
rewind starter to bring the piston at top
position. Pour the equivalent of one
spoonful of oil into spark plug hole.
Slowly crank the engine several times
using the manual starter. Repeat above
steps for other cylinder. Install the
spark plugs.
. . , CAUTION: To prevent ignition
. . system damage, make sure that
the cut-out button is in the lower posi-
tion.
19