Table of Contents
Advertisement
OPERATING INSTRUCTIONS CHECKLIST
BEFORE OPERATING THIS APPLIANCE, CAREFULLY
PROCEED THROUGH THE FOLLOWING CHECK LIST.
1.
Read and understand these instructions before installing or operating this
appliance.
2.
Installation of this appliance is only to be carried out by a licensed gas fitter who
preferably should be familiar with the installation of the Archer Heater.
3.
Installers who are not familiar with the installation of this appliance should
contact Aurora Climate Systems prior to installing the appliance to avoid
creating hazardous operating conditions.
4.
No deviations on installation are allowed, unless they are specifically approved in
writing by the manufacturer of the appliance.
5.
Wrongful or deviations taken by the installers on the installation of this
appliance, will result in the heater not starting up or operating incorrectly
causing a safety hazard and will void the manufacturer's warranty of the
appliance.
6.
Check and inspect the appliance for gas leaks. In the event of gas leaks, cut off the
gas supply to the heater immediately and call your gas supplier or installer.
7.
Check and verify that all flue venting combustion air intakes and flue cowl are
unobstructed.
8.
Refer to page 13 for Single Flue pipe and page 14 for Co-Axial Flue installations,
that correct flue pipe and cowl has been fitted in line with the manufacturer's
specifications as illustrated in the Installation Manual Pages 13-20.
9.
Do not use alternative Flue or Cowl on installation other than that specified in
this manual - otherwise heater will malfunction and cause hazardous operating
conditions and will void the manufacturer's warranty.
10.
Check and verify that flue pipe connection to the appliance when using single
40mm flue pipe installation is correctly installed and secured in line with
instruction in the Installation Manual Pages 16-20.
29
Hide quick links:
Advertisement
Table of Contents
