Table of Contents
Advertisement
Battery
1. Do not disassemble or reconstruct batter y.
2. Do not short-circuit batter y
3. Do not use or leave batter y nearby fire, stove or heated place(more
than 80 ℃)
4. Do not immerse the batter y in water or sea water , or get it wet
5. Do not charge batter y nearby the fire or under the blazing sun
6. Do not drive a nail into the batter y. Strike it by hammer, or tread it
7. Do not give batter y impact or fling it
8. Do not use the batter y with conspicuous damage or deformation
Aircraft backlight Signal indication
Aircraft power-on, initialization is completed, backlight state, then you can unlock motors
A.Backlight flashes RED-YELLOW-GREEN
B.Backlight flashes GREEN
After the motors has been unlocked ,backlights state, then you can push up the throttle to take off
A.Backlight flashes
this indicates Seraphi is unlocked, but no GPS signal.
B.Backlight turn off
, this indicates Seraphi is unlocked ,with GPS signal.
During flying ,voltage alarm
A.During flying,backlight flashes RED-GREEN
B.During flying,backlight flashes GREEN
I.Flying warnings
1.For the first flying, beginners are strongly suggested taking necessary trainings by professionals or doing some pre-exercises on
simulators until you can skillfully operate the aircraft or the simulator and the
2. During flying, please make sure that Seraphi is always within sight and its back light always faces its operator so that he could
determine its flight attitude and adjust its flight directions when necessary.
3. During flying, what's more, please watch the flash of back light at any time and keep alert to Low-Voltage signals. Low-Voltage Alert is
to indicate that the battery cannot provide enough power for the aircraft and you should land the aircraft
4. Sensors in the heart of SeraphI are damageable, so be sure not to hit or drop the aircraft heavily. Otherwise, the inertial measuring unit
(IMU) might be destroyed. If Seraphi flies in an abnormal way after being hit or dropped Seriously, please return it to Yunyi-Flight to repair
immediately.
II. Preparations for Flying
Horizontal calibration Steps
Place seraphi on horizontal ground, power on .when backlight
flashes GREEN-YELLOW-RED
up switch bottom
in GPS mode , Pull the left and right stick to
the left bottom
at same time, back light flash rapidly, release
the sticks, Afer 10 seconds, when backlight flashes GREEN-
YELLOW-RED
or flashes GREEN
successful.
NOTE:
1.In any Drop or rollover cases or the first use or did not use it for a long time.You should carry out this step. This will ensure a stable
flight .
2.you should ensure the aircraft put on a horizontal ground,keep it still,do not move seraphi during calibrating.
this indicates initialization is completed but without GPS signal.
this indicates initialization is completed. with GPS signal.
this indicates voltage alarm,with GPS signal.
or flashes GREEN
,horizontal calibration is
10. Do not reverse charge or overdischarge the cell
11. Do not reverse-charge or reverse-connect
12. Do not connect battery to the plug socket or car-
cigarette-plug
13. Do not use battery for unspecified equipment
14. Do not use Lithium ion battery in mixture
15. Keep the battery away from babies
16. Do not get into a microwave or a high pressure
container
17. Do not use a leaked battery nearby fire
18. Do not use an abnormal battery
this indicates voltage alarm,no GPS signal.
remote controller
Pull the
ASAP
to avoid or reduce crashes
6
Advertisement
Table of Contents
