Advertisement
SySTEM COMPONENTS
Please check your system and
confirm you have received the
following LES-391 SoundPak
components:
DAILy SETUP
1. REMOvE THE CHARGING CORDS
After being fully charged, remove the charging cords
from the 370T and the 380R.
4. TURN ON/ADJUST vOLUME OF 370T
the power switch of the 370T to the left to the ON
position. (Note: the center is the MUTE position). Rotate the
volume knob on the 370T to approximately mid-way
(you may need to adjust this later
depending on the volume of
the teacher's voice).
370T
belt-pack
transmitter
380R Receiver/
amplifier and Carrybag
2. CHECK FREQUENCIES
Check that the frequency on the 370T and
the 380R match (for example, both set on
channel A or both set on channel B).
5. TURN ON/ADJUST vOLUME OF 380R
Place the 380R on the student desk with speaker facing the
student. Turn on the power switch by rotating the "Power/
vol" switch clockwise until it clicks on. Continue to rotate the
volume knob clockwise until the desired volume is achieved.
CAUTION: If the mic is too close speaker, feedback may occur
(a howling sound). To eliminate this problem, decrease the
volume level and/or move farther away from the 380R.
TK-250M
headset
microphone
Rechargeable AA
Nickel Metal Hydride
(NiMH) batteries
3. PUT ON THE HEADSET
Insert the TK-250M
headset microphone
plug into the mic jack on
the top of the 370T and
position the TK-250M
along the left jaw line.
Proper positioning is
achieved by running the
headband over the top
of the left ear, around
the back of the head (not
over the top), and then
over the right ear. The
microphone element and
wind screen should be
positioned about an inch
from the left corner of
the mouth. The TK-250M
boom is adjustable.
The headband may be
resized by grasping
both ends of the wire
headband and either
stretching it farther apart
or rolling the loop into a
tighter circle.
6. CONSERvE BATTERy STRENGTH
To conserve battery life, the 370T and 380R should be
turned off when not in use.
BC-370 Wall Charger
for the transmitter
BC-1A Wall
Charger for
receiver/amplifier
Advertisement
