WELCOME Congratulations to your purchase of this Elmwood Bonneville 50 Watt Combo. The 50 watt tube amp will give you an awesome quality and response, no matter if you are into jazz, blues or hard rock. With the special Boost function on both channels you can go from a nice clean sound, to dirty blues sound, to crunchy rhythm sound, to heavy lead sound, just by controlling the footswitch.
PRECAUTIONS & WARNINGS PRECAUTIONS & WARNINGS PRECAUTIONS & WARNINGS PRECAUTIONS & WARNINGS Always follow the safety instru Always follow the safety instructions listed here and use common sense. listed here and use common sense. Read this manual carefully before switching on your amplifier. Read this manual carefully before switching on your amplifier.
EQ settings and channel switching. An Elmwood will be your best companion no matter what your style of playing - from soft whispers to hard punches - from lush clean to screaming high gain - from heaven to hell - always interacting with your deepest musical intentions.
GETTING STARTED Getting started 1. Connect the amplifier to the mains. ct the amplifier to the mains. 2. Make sure the internal speaker(s) is connected Make sure the internal speaker(s) is connected to the 8 ohm jack socket jack socket . If use with internal and/or external speaker cabinets nd/or external speaker cabinets, make sure the impedance , make sure the impedance...
Turning the Gain knob counter clockwise will decrease the Gain and clean up the sound. Use the Channel 2's Volume knob to set a good balance between Channel 1 and Channel 2. Bonneville 50 – Owner’s Manual – Ver: 2.2 Elmwood Amps...
Note: The Boost Led on the Footswitch will not light up when Master 1 is activated .In this mode the Boost might affect the Master 1 properly. output Volume . Make sure to adjust the Bonneville 50 – Owner’s Manual – Ver: 2.2 Elmwood Amps...
The two Master Volumes The Bonneville 50 is equipped with two Footswitchable Master Volumes. This is to be able to have any sound you are playing in a louder version at any time. Master 1 is controlling the maximum volume level of the amplifier and is used for setting the lead volume level.
BACK PANEL Back panel On the back panel there are 4 speaker back panel there are 4 speaker outputs for connecting internal and/or external ternal and/or external speakers. Make sure the internal speaker(s) is connected to the Make sure the internal speaker(s) is connected to the 8 ohm jack socket. If use with internal and/or external speaker cabinets, make sure the impedance matching If use with internal and/or external speaker cabinets, make sure the impedance matching If use with internal and/or external speaker cabinets, make sure the impedance matching...
Page 11
Connect the amplifier to a earthed mains outlet. Fuse 1 AT Replace broken fuse only with the same type - Voltage/Current. The fuse is a 1 Ampere / 250 Volts slow blow. Bonneville 50 – Owner’s Manual – Ver: 2.2 Elmwood Amps...
Need help?
Do you have a question about the Bonneville 50 and is the answer not in the manual?
Questions and answers