Installation And Operation - NGS FORTRESS User Manual

USER'S MANUAL

INSTALLATION AND OPERATION

Installation for Standard UPS
1. Shut down the load (for example PC), pull out power gird.
2. Put UPS on the proper position (following the manual).
3. Connect load (for example PC) to the UPS.
4. Put the plug to the AC power socket (make sure GND is
connected well).
4
Fuse
Input
5. Connect to AC: press the panel switch turning on the UPS,
the green LED and yellow LED light, then you can turn on your
computer etc.
6. Battery mode: press the panel switch turning on the UPS, the
red LED lights, then you can turn on your computer etc.
7. Normally turning UPS: press the panel switch turning on the
UPS.
8. Normally turning off UPS: press the panel switch turning off
the UPS.
Output