Page 1
INSTR_800-2655-3_MM2.qxd 9/26/05 10:32 AM Page 1 ® WARNING READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS IN THIS MANUAL TO AVOID PERSONAL INJURY OR PROPERTY DAMAGE. WARNING TO PREVENT DAMAGE TO EYESIGHT, NEVER LOOK INTO SPOTLIGHT WHEN LIGHT IS ON. DO NOT SHINE LIGHT INTO THE FACE OF SOMEONE ELSE.
INSTR_800-2655-3_MM2.qxd 9/26/05 10:32 AM Page 2 IMPORTANT SAFETY WARNINGS READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL BEFORE OPERATING SPOT/FLOOD LIGHT. WARNING • Never place spot/flood light face down when light is on or is still hot from recent use. Doing so could burn/ignite surfaces such as seats, carpeting, etc.
INSTR_800-2655-3_MM2.qxd 9/26/05 10:32 AM Page 3 OPERATING INSTRUCTIONS READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL BEFORE OPERATING SPOT/FLOOD LIGHT. Inspect contents of the box to ensure all parts are included and undamaged. Part List: Q-Beam Max Million™ I I I I Rechargeable Spot/Flood Light 2 Rechargeable Batteries...
Page 4
INSTR_800-2655-3_MM2.qxd 9/26/05 10:32 AM Page 4 To Charge THE BATTERY CAN BE CHARGED INSIDE OR OUTSIDE OF SPOT/FLOOD LIGHT. To Charge Battery Inside of Spot/flood light: Step 1: Make sure the trigger switch is not locked ON. Step 2: Plug the AC charger directly into back of battery or DC charger/adapter into bottom of spot/flood light handle.
Page 5
INSTR_800-2655-3_MM2.qxd 9/26/05 10:32 AM Page 5 To Charge Battery Outside of Spot/flood light: Battery Step 1: Remove battery from back of spot/flood light by pressing on the quick-release tabs. Step 2: Plug the AC charger into battery as illustrated. Note: L.E.D.
Page 6
INSTR_800-2655-3_MM2.qxd 9/26/05 10:32 AM Page 6 Connector Step 5: Holding the front housing secure, slowly lift the rear housing off. Step 6: Pull reflector away from rear housing carefully. Do not touch the inside of reflector. NOTE: The glass lens is not attached to front housing. Use care when disassembling to avoid breaking lens.
Page 7
INSTR_800-2655-3_MM2.qxd 9/26/05 10:32 AM Page 7 To Replace Cigarette Step 1: Disconnect spot/flood light from power source. Lighter Plug Fuse Lighter Plug Step 2: Unscrew cap of lighter plug and pull straight away from fuse. Step 3: Pull fuse holder and fuse out of lighter plug. Observe to see if fuse is burned out.