Intex Krystal Clear CS8220G Owner's Manual page 27

TROUBLESHOOTING GUIDE (continued)
LED PANEL
CODE
LED Panel Code Flash & Alarm On (NOTE: Always turn off the power before cleaning and servicing).
1. Filter pump not attached to
system and/or switch on.
2. Circulation line is blocked.
3. Incorrect inlet and outlet hose
direction.
4. Incorrectly installed flow sensor
conduit.
5. Scale on the flow sensor.
6. Flow sensor cord is loose.
7. Inner timer conflict between
filter pump and saltwater system.
8. Flow sensor failure.
1. Dirt or scale on titanium plates.
2. Low salt level / No salt.
3. Electrolytic cell cord is loose.
4. Possible electrolytic cell failure.
1. High salt level.
1. Display and all lights are off - the
system does not power up.
SAVE THESE INSTRUCTIONS
(132GS) MODEL CS8220G SALTWATER SYSTEM ENGLISH 7.5" X 10.3" PANTONE 295U 11/17/2011
PROBLEM
• Ensure filter pump is attached and
• If your unit has plunger valves, ensure
• Clear your filter cartridge and cell from
• Release all trapped air in the circulation
• Check the direction of the inlet and the
• Check that the arrow on the flow sensor
• Clean the flow sensor, paying special
• Plug the flow sensor firmly into the flow
• Reset both timers on the filter pump and
• Contact Intex Service Center.
• Remove the electrolytic cell for
• Add salt. See "Salt & Pool Water
• Ensure that the cell cord is plugged
• Contact Intex Service Center. Replace
• Partially drain the pool and refill it with
• Household voltage is too high or too low
• Contact Intex Service Center.
English
SOLUTION
operating. See "Setup Instruction".
that they are open.
debris and dirt. See "Maintenance".
line. See the filter pump manual.
outlet hose. Reverse the hoses if
necessary. See "Set Up Instructions".
conduit points in the same direction as
the one on the cell. Reverse the flow
sensor conduit if necessary.
attention to the hinge. See
"Maintenance".
sensor receptacle.
saltwater system.See "Boost Cycle".
inspection. Clean it if necessary.
See "Maintenance".
Volumes".
firmly into the cell housing receptacle.
the cell if needed.
fresh water. See "Salt & Pool Water
Volumes".
(+ 20%). Check the voltage is within the
range stated on the device housing.
Page 27
132
GS