Table of Contents
Advertisement
Quick Links
A U T O M A T I C
Introduction............................................. 2
Using the Remote Control ...................... 2
Feature Confirmation Chart .................... 3
Vehicle Status Request .......................... 3
Running .................................................. 4
Running .................................................. 4
How Run Time Cycles Work................... 5
Multi-Level Features (default state)....... 6
Remote-Starting Your Vehicle ................ 7
Vehicle Presets....................................... 7
Driving Off............................................... 7
Using the Remote Starter ....................... 8
Arming the Starter Kill............................. 8
Idle Mode................................................ 8
Turbo Mode ............................................ 8
Valet Mode.............................................. 8
installed) ................................................. 8
Ignition Valet ........................................... 9
Remote Valet Mode................................ 9
Panic Mode........................................... 10
DOC:.1.11
T R A N S M I S S I O N
NTW-2000
User Guide
Table of Contents
- September 27, 2004
R E M O T E
.................................... 10
Cold Weather Mode.............................. 10
programmable Options ......................... 10
Remote Door Locks.............................. 11
Priority Door Access ............................. 11
Active or Passive Arming...................... 11
.............................................................. 11
Flashing LED ........................................ 11
Safe Start.............................................. 11
....................................... 12
Ignition-Controlled Door Locks ............. 12
Ignition Re-lock..................................... 12
Secure Lock.......................................... 12
Turbo Mode .......................................... 12
Remote Trunk Release......................... 12
Engine Run Time.................................. 12
Extended Run Time.............................. 12
Multi-car Operation ............................... 12
CA LP
S T A R T E R
Manufactured in Canada
Advertisement
Table of Contents
Summary of Contents for Nordic NTW-2000
-
Page 1: Table Of Contents
A U T O M A T I C T R A N S M I S S I O N R E M O T E S T A R T E R NTW-2000 User Guide Table of Contents Introduction..........2 Quick Lockout ........ -
Page 2: Introduction
Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a remote starter (see Multi-car operation section on page 12). The functions of the transmitter are as follows: Picture serves as example only. P. 2 User Guide NTW-2000... -
Page 3: Feature Confirmation Chart
If the engine IS running under a remote start, refer to Table 2 (if the doors are locked) or refer to Table 3 (if the doors are unlocked). The status request feature is a two-step procedure: • The first sequence of flashes denotes if the vehicle’s doors are locked or unlocked. NTW-2000 Guide d’installation P. 3... -
Page 4: Status Request When The Engine Is Not Running
3 flashes more than 1/4 of run sequence ON for 1-sec ON for 1-sec time cycle If there is less sequence 3 flashes than 1/4 of run time cycle 2 sequence ON for 1-sec Table 2 P. 4 User Guide NTW-2000... -
Page 5: How Run Time Cycles Work
30-minute run ... the cycle will ... 23 minutes ... 16 minutes ... 9 minutes into time cycle have ended. into the cycle. into the cycle. the cycle. Table 4 NTW-2000 Guide d’installation P. 5... -
Page 6: Multi-Level Features (Default State)
2X) SHIFT Level 3 Customized features (requires pressing the button 3X) SHIFT Option 2: Level 1 Basic features (requires pressing the button 1X) SHIFT Level 2 Multi car operation (requires pressing the button 2X) SHIFT P. 6 User Guide NTW-2000... -
Page 7: Remote-Starting Your Vehicle
IGNITION ON (RUN) CRANK while the engine is running. This would cause the starter motor to re-engage.) Press the brake pedal to disengage the remote starter unit. You are now ready to drive off. NTW-2000 Guide d’installation P. 7... -
Page 8: Using The Remote Starter
When your vehicle is in valet mode, the remote starter functionalities are disabled. If the vehicle needs to be serviced, or if you park it indoors, the valet mode will prevent the engine from being remote-started accidentally. To put the system i n t o valet mode: P. 8 User Guide NTW-2000... -
Page 9: Ignition Valet
Within 3 seconds, press the buttons simultaneously until the LOCK START/STOP parking lights go out To take the system o u t o f home valet mode: • Turn the ignition key to the position. IGNITION ON (RUN) NTW-2000 Guide d’installation P. 9... -
Page 10: Panic Mode
: The programming of your system should be left to a professional. Changing any one of the settings may affect the operation of your remote starter. The installation-programmable options are as follows: Remote Door Locks Ignition Re-lock Priority Door Access Secure Lock P. 10 User Guide NTW-2000... -
Page 11: Remote Door Locks
If this feature is enabled, the user must press the button 2 times within 3 seconds to START/STOP remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing with the transmitter. NTW-2000 Guide d’installation P. 11... -
Page 12: Home Valet Tm
To control the second vehicle, simultaneously press the button and the button of the function you wish to use. TRUNK Note: Your remote control must be configured for second car operation by the installer. P. 12 User Guide NTW-2000... -
Page 13: Troubleshooting Transmitting Range
Always hold the transmitter high, approximately at shoulder height. Holding the transmitter against your chin will also increase your range: your head acts as an antenna. • The operating range will be somewhat lower on vehicles equipped with an aftermarket or factory alarm. NTW-2000 Guide d’installation P. 13... -
Page 14: Diagnostics - Parking Light Flash Table
• If the unit gives irregular signals (1 to 10 flashes followed by a pause, Irregular followed by further flashes), the system is playing back start failure codes. This occurs when the hood pin-switch is pressed three times Constant • Panic mode is triggered. flashes up to 30 sec. P. 14 User Guide NTW-2000...
Need help?
Do you have a question about the NTW-2000 and is the answer not in the manual?
Questions and answers