Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Bosch SMS50E22AUW
Summary of Contents for Bosch SMS50E22AUW
- Page 1 Dishwasher Operating instructions...
- Page 2 Reset 3 sec. Start...
-
Page 3: Table Of Contents
en Table of contents Safety instructions ....4 Washing the dishes ....14 Delivery . -
Page 4: Safety Instructions
– Read and observe the safety Safety instructions information and instructions for use on the packaging for cleaning and rinsing Delivery agents. – Check the packaging and dishwasher ã= immediately for damage caused in Warning transit. Do not switch on a damaged Knives and other utensils with sharp points appliance, but contact your supplier. -
Page 5: Door Lock
Childproof lock (door lock) * Getting to know your The description of the childproof lock is at appliance the back in the envelope. * depending on model Diagrams of the control panel and the interior of the appliance can be found in Damage the envelope at the front. -
Page 6: Rinse Aid
Setting amount of rinse aid Rinse aid % The amount of rinse aid dispensed can be set from : to : As soon as the rinse-aid refill indicator ` Do not change the amount of rinse aid is lit on the fascia, there is still a rinse-aid unless streaks (select lower setting) or reserve of 1 –... -
Page 7: Utensils
Loading the dishwasher Utensils – Remove large food remnants. It is not necessary to prerinse utensils under Not suitable running water. – Cutlery and utensils made of wood. – Place the utensils so that – Delicate decorative glasses, craft and –... -
Page 8: Pans
Pans Cutlery basket Bottom basket 1Z You should always place cutlery unsorted with the points downwards. To prevent injuries, place long, pointed implements and knives on the knife shelf. Folding spikes * * depending on model The spikes can be folded down to improve arrangement of pans, bowls and glasses. -
Page 9: Small Accessories Holder
Small accessories holder * Adjusting the height of the basket * * depending on model Light-weight plastic accessories, e.g. cups, * depending on model lids, etc. can be held securely in the small If required, the height of the upper utensils accessories holder. -
Page 10: Detergent
Top basket with side levers Detergent – Pull out the top basket 1" out. – To lower the basket, press in the left You can use tablets as well as powder and then the right lever on the outside or liquid detergents for dishwashers, but of the basket. -
Page 11: Adding Detergent
Adding detergent If the utensils are only lightly soiled, slightly – If the detergent dispenser 1j is still less than the indicated amount closed, press the lock 9" to open the of detergent is usually adequate. detergent dispenser. Suitable detergents and care products Pour detergent into the dry detergent can be purchased online via our website dispenser 1j only (insert tablet flat,... -
Page 12: Overview Of Programmes
Overview of programmes The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. The programme data has been measured in the laboratory according to AS/NSZ 2007. Programme Type of utensils Programme Possible... -
Page 13: Programme Selection
Programme selection Additional options You can select a suitable programme according to the type of utensils and * depending on model degree of soiling. Additional options can be set with the buttons X. Information for test institutes Ÿ Test institutes can request the conditions Express Wash * for running comparison tests by sending an e-mail to... -
Page 14: Washing The Dishes
Remaining running time display Washing the dishes When the programme is selected, the remaining running time of the programme Programme data is indicated on the digital display H. The programme data (consumption The running time is determined during the values) can be found in the summary of programme by the water temperature, the instructions. -
Page 15: Switching Off Automatically After The End Of The Programme
Switching off automatically after ã= Warning the end of the programme * At the end of the programme please open * depending on model the door fully and not partially when To save energy, the dishwasher is emptying the dishwasher. Any escaping switched off 1 minute after the programme water vapour could damage sensitive ends (factory setting). -
Page 16: Changing The Programme
Changing the programme Maintenance and care When the START button @ has been pressed, the programme cannot be A regular inspection and maintenance of changed. your machine will help to prevent faults. The only way a programme can be This saves time and prevents problems. changed is by Cancel programme (Reset). -
Page 17: Filters
Filters Spray arms The filters 1J keep large foreign objects Limescale and contaminants in the rinsing in the rinsing water away from the pump. water may block nozzles and bearings on the spray arms 1: and 1B. These foreign objects may occasionally block the filters. -
Page 18: Troubleshooting
Waste water pump Troubleshooting Large food remnants in the rinsing water not retained by the filters may block the The majority of faults which could occur in waste water pump. The rinsing water is daily operation can be rectified by the then not pumped out and covers the filter. -
Page 19: When The Appliance Is Switched On
“Check water supply” display h lights ... when the appliance is switched on – Tap turned off. The appliance does not start. – Water supply interrupted. – The mains fuse has tripped. – Supply hose kinked. – The appliance plug has not been –... -
Page 20: During The Wash Cycle
... during the wash cycle Streaks on glasses and cutlery, glasses have metallic appearance. Unusual foam formation. – Too much rinse aid. – Handwash liquid in the rinse aid Plastic parts discoloured. dispenser. – Too little/unsuitable detergent. Spilled rinse aid causes excessive –... -
Page 21: Customer Service
Customer service Installation If the advice given does not resolve your The dishwasher must be connected problem, please contact your customer correctly, otherwise it will not function service. Contact details can be found on properly. The specifications for the inlet the back cover of this instruction manual and outlet as well as the electrical or in the enclosed customer service list. -
Page 22: Delivery
– Install built-under or integratable Technical specifications appliances only under continuous Weight: worktops which have been screwed to max. 60 kg adjacent cupboards to ensure stability. Voltage: – Do not install the appliance near heat 220–240 V, 50 Hz or 60 Hz sources (radiators, heat storage tanks, cookers or other appliances which Connected load:... -
Page 23: Waste-Water Connection
Waste-water connection Warm water connection – The required work sequence can be * depending on model found in the installation instructions. If The dishwasher can be connected to cold required, fit a siphon with an drainage or hot water up to max. 60 °C. connection. -
Page 24: Electrical Connection
Electrical connection Transportation – Connect the appliance to an alternating Empty the dishwasher and secure loose current only, ranging from 220 V to parts. 240 V and 50 Hz or 60 Hz via Drain the appliance according to the a correctly installed socket with following steps: protective earth conductor. -
Page 25: Waste Disposal
Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. Please dispose of the individual parts separated according to type. Please ask your dealer or inquire at your local authority about current means of disposal. - Page 27 Childproof lock (door lock) * 40 Activate the childproof lock. Always close the appliance door completely 41 Open the door with activated when you leave the appliance. childproof lock. This is the only way you can protect your 42 Deactivate childproof lock. children from potential dangers.
- Page 28 The tap should only be turned off if you are absent from home for a prolonged period, e.g. several weeks holiday. Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München To book an engineer visit and product advice...