Table of Contents
Advertisement
Installation Guide
Panel mounting
Before you begin, note that:
The mounting panel cannot be more than 5 mm thick.
To minimize electromagnetic interference, mount the controller on a metal panel and
earth the power supply according to the details in step 2 below.
1. Make a panel cut-out according to the dimensions shown below.
Cut-out Dimensions
2. If you mount the controller on a metal panel, earth the power supply:
a. Bore a hole to suit the NC6-32 screw supplied with the kit.
b. Scrape panel paint away from the contact area to ensure a conductive
connection.
c. Drive the screw into the hole.
d. Place the following hardware screw's shank, in the order shown in the
accompanying figure: washer, ring cable shoe, second washer, spring,
and nut.
Note:
The wire used to earth the power supply must not exceed 10 cm in
length. If your conditions do not permit this, do not earth the
power supply.
Unitronics
3
Advertisement
Table of Contents
