NordicStart NTW-2200 User Manual

Two-way lcd automatic transmission remote starter

Advertisement

TWO-WAY LCD AUTOMATIC TRANSMISSION REMOTE STARTER
A note concerning the battery inside the transmitter:
Depending on your usage of the transmitter, the battery can last anywhere between 3 to 6 months.
When the battery is low, the transmitter will produce two beeps in a repetitive cycle. At that point
you should replace your battery with a new one. That is why we recommend that you keep a
spare battery somewhere handy such as the glove compartment.
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(EIRP) is not more than that required for successful communication.
FCC USER NOTICE (U.S.A.):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
undesired operation.
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
Introduction ..................................................2
Using the Transmitter......................................2
Remote-Starting Your Vehicle...........................2
Driving Off....................................................2
Using the Remote Starter.................................2
Arming the Starter Kill.....................................2
Idle Mode.....................................................2
Turbo Mode..................................................3
Ignition Valet.................................................3
Remote Valet Mode........................................4
Panic Mode..................................................4
.............................................4
TM
Cold Weather Mode........................................4
Options........................................................5
Remote Door Locks........................................5
Priority Door Access .......................................5
Active or Passive Arming.................................5
Flashing LED................................................5
Safe Start.....................................................6
...............................................6
Ignition-Controlled Door Locks..........................6
DOC:.1.51
NTW-2200
User Guide

Table of Contents

- October 31, 2005
Ignition Re-lock..............................................6
Secure Lock.................................................6
Turbo Mode..................................................6
Remote Trunk Release....................................6
Engine Run Time...........................................6
Extended Run Time........................................6
Multi-car Operation.........................................6
LCD Remote Functions ...................................8
Basic Vehicle Operations.................................8
Transmitter Mode Selection..............................8
Time or Alarm Clock Adjustments ......................8
Cold Weather Mode........................................9
................................................9
Safe Start Mode.............................................9
Timing Countdown Adjustment..........................9
Basic Operations ......................................... 10
Transmitter Functions ................................... 11
CA FB TL
................................. 10
................ 10
Manufactured in Canada

Advertisement

Table of Contents
loading

Summary of Contents for NordicStart NTW-2200

  • Page 1: Table Of Contents

    TWO-WAY LCD AUTOMATIC TRANSMISSION REMOTE STARTER NTW-2200 User Guide A note concerning the battery inside the transmitter: Depending on your usage of the transmitter, the battery can last anywhere between 3 to 6 months. When the battery is low, the transmitter will produce two beeps in a repetitive cycle. At that point you should replace your battery with a new one.
  • Page 2: Introduction

    Introduction This is a state-of-the-art remote starter system. The system is packed with advanced features such as priority access to the driver’s door (commodity features) and the safe start children safety feature. With many an advanced function, this product will satisfy any one of your expectations from high-end commodity and security systems, without neglecting any standard feature commonly offered by entry-level starters.
  • Page 3: Turbo Mode

    To leave the vehicle in idle mode: 1. With the engine running, press the button (to unlock the doors) or the LOCK UNLOCK button on the remote control until the parking lights come on. START/STOP 2. Remove the key and exit the vehicle. The engine will go on running. 3.
  • Page 4: Remote Valet Mode

    Remote Valet Mode This feature will allow you to remotely put your system into valet mode by using the transmitter instead of the valet button as above. Getting into Remote valet mode • Hold the buttons simultaneously for 3 second. UNLOCK START/STOP •...
  • Page 5: Advanced Features: Installation-Programmable Options

    • Press the button and then the button for three seconds. FUNCTION START/STOP • There will be one (1) beep and the parking lights will flash once. To verify whether the system is in cold weather mode: Press the brake pedal: If the vehicle is in cold weather mode, the parking lights will stay on while the pedal is pressed.
  • Page 6: Safe Start

    iii. The LED will flash once the starter kill is activated but requires pressing the UNLOCK button to turn itself off. Failure to press the button will make the LED flash UNLOCK even if the key is in the position. IGNITION ON Safe Start If this feature is enabled, the user must press the...
  • Page 7: Troubleshooting Transmitting Range

    Press Ø Ø + :........ FUNCTION FUNCTION LOCK LOCK Press Ø Ø + : ......FUNCTION FUNCTION UNLOCK UNLOCK Press Ø Ø + FUNCTION FUNCTION START/STOP:........START Press Ø Ø + ....... FUNCTION FUNCTION START/STOP: STOP Troubleshooting Transmitting Range Many factors may affect the operating range of the transmitter. Some of these are: •...
  • Page 8: Lcd Remote Functions

    This constant pulse can be configured to activate certain functionalities such as rolling down the windows – Please refer to your installer to see if your vehicle is compatible with this option. LCD Remote Functions The transmitter offers several command-confirmation and timer features. This section explains some of the key functions available.
  • Page 9: Cold Weather Mode

    7X........Adjust hour (countdown) b. Press the to decrease the value or to 8X......Adjust minutes (countdown) activate or deactivate a function or to toggle 9X....Melody selection for the countdown through the melodies. 10X ..Activate (ON) / Deactivate (OFF) countdown c.
  • Page 10: Lcd Transmitter Operation And Confirmations (Second Car Control)

    *Runtime Status (Indication purpose only) Function By pressing Icon Gasoline Diesel 4 minutes 9 minutes Engine runtime 15 minutes 20 minutes 25 minutes 30 minutes LCD Transmitter Operation and Confirmations (Second Car Control) Basic Operations Function Button press Icon Sound Description Lock 1 beep...
  • Page 11: Accessing The Multi-Level Features And Other Transmitter Functions

    Ø ............aux 2 FUNCTION LOCK: Ø ..........cold weather FUNCTION START/STOP Multi-Car Operation (press the button 2X) FUNCTION :......2 car lock Ø Ø FUNCTION FUNCTION LOCK : ....2 car unlock Ø Ø FUNCTION FUNCTION UNLOCK :....2 car start/stop Ø Ø FUNCTION FUNCTION START/STOP : ......2...
  • Page 12: Diagnostics - Parking Light Flash Table

    Level 3 ( Multi car operation à requires pressing the button 3X) FUNCTION Example: If the multi-level features were set to option 3, the setup would be as follows: – Level 1 à Customized feature – Level 2 à Multi car operation –...

Table of Contents