Table of Contents
Advertisement
Quick Links
WARNING: Do not assemble, install or operate this equipment without reading ALL
of this manual and the safety precautions and warning illustrated in this manual.
KDAR Company
15009 Manchester Rd. #283
Ballwin, MO 63011
Operator's Manual
Portable Generator
Model: HM2000
Tel: 314-692-8555
Fax: 314-692-8578
Web: www.hotmaxtorches.com
Advertisement
Table of Contents
Related Manuals for Hot Max HM2000
Summary of Contents for Hot Max HM2000
- Page 1 Operator’s Manual Portable Generator Model: HM2000 WARNING: Do not assemble, install or operate this equipment without reading ALL of this manual and the safety precautions and warning illustrated in this manual. KDAR Company Tel: 314-692-8555 15009 Manchester Rd. #283 Fax: 314-692-8578 Ballwin, MO 63011 Web: www.hotmaxtorches.com...
- Page 2 5. Always remove the spark plug or spark 11. Do not touch engine muffler or other plug cable before performing mainte- engine or generator parts which get nance to avoid accidental starting. hot during operation. KDAR Company...
- Page 3 24. Drain fuel before transporting the gen- a poisonous, odorless, invisible gas erator. 25. Generators are heavy, use proper lifting which, if breathed, may cause death techniques. or personal injury. KDAR Company...
-
Page 4: Features And Benefits
18. Noise Level of 67 dB(A) @ 24 Ft. 9. 12 Volt DC Circuit, 8.3 Amps, Battery Charger 19. Run Time of 11 Hours at 50% Load 10. All Outlets Circuit Protected Package Contents 1. Generator 2. Operator’s Manual 3. Warranty Card 4. Spark Plug Wrench KDAR Company... -
Page 5: Air Filter
Switch Panel Plug Carburetor Filler Choke Muffler Filter Manual Fuel Recoil Valve Starter Ground 120V AC 20 Amp Terminal Outlet Voltage Meter 120/240V AC DC Connection Fuel Level Gas Cap 12.5 Amp L14-30 Outlet Battery Charge Only Gauge KDAR Company... -
Page 6: Engine Preparation
3. Do not fill tank above the shoulder of the fuel strainer. Strainer Shoulder 4. Fill with .63 quarts (.6 Li- ters) of motor oil. 5. Confirm proper fill by re- placing the dip stick and checking the oil level. KDAR Company... -
Page 7: Grounding The Generator
5. Avoid getting dirt or water in the fuel tank. Grounding the Generator KDAR recommends generators be properly con- nected to an appropriate earth ground to help pre- vent electric shock. The ground terminal found on the control panel is connected to the frame of the generator for this purpose. -
Page 8: Operation
Apply load only after the generator is running • and has warmed up for 5 minutes. Voltage is regulated by the speed of the engine • which is adjusted at the factory for correct out- put. Readjusting will void the warranty. KDAR Company... -
Page 9: Shutting Off The Generator
3. Flip ON/OFF switch to the “OFF” position. 4. Make sure the generator has completely stopped. 5. Close the fuel shut off valve if the generator is to be stored or transported. KDAR Company... -
Page 10: Maintenance Schedule
Air Cleaner Service thoroughly (a nonflammable or high flash point solvent can also be used). 1. Unsnap the air cleaner cover clips. 4. Re-install Arrestor and tighten Clamp. 2. Remove the air filter element. KDAR Company... -
Page 11: Fuel Filter Cleaning
Never use spark plugs which have an improper If the engine has been running, the muf- heat range. Use only the recommended spark fler will be very hot. Care must be taken plugs or equivalent. not to touch the muffler when removing the spark plug. KDAR Company... -
Page 12: Preparing For Transportation
Storing the engine in After removal from storage, drain the • this position will help protect it from internal stored gasoline into a suitable container corrosion. and fill with fresh gasoline before start- ing. KDAR Company... -
Page 13: Troubleshooting
2. Fuel should flow from the drain when the fuel valve is turned on. If the engine still does not start, take the genera- NOTE: The nearest KDAR authorized ser- tor to a authorized vice center can be found by visiting KDAR service center. -
Page 14: No Electricity At The Ac Receptacles
KDAR authorized service fects. center. DEFECTS Replace the electrical ap- pliance or equipment or NOTE: The nearest KDAR authorized ser- take the appliance or vice center can be found by visiting equipment to an electrical www.hotmaxtorches.com. repair shop. KDAR Company... - Page 15 Electric Drill 1/2" - 5.4 Amp Electric Drill 3/8" - 4 Amp Running Watts Requirement: Halogen Work Light - 1000 1000 Watt Peak Watts Required (A+B): Reciprocating Saw Office Equipment Computer w/Monitor 1600 Copy Machine Fax Machine Laser Printer KDAR Company...
-
Page 16: Limited Warranty
Implied warran- ties, including warranties of merchantability KDAR Company, and its affiliates, will repair or and of fitness for a particular purpose, are replace, at KDAR’s sole discretion, parts found to hereby disclaimed. The warranty service de-...
Need help?
Do you have a question about the HM2000 and is the answer not in the manual?
Questions and answers